MasterPage: Left
GR-DX97US.book Page 18 Monday, February 9, 2004 2:28 PM
VIDEO PLAYBACK18 EN
Shuttle Search
Connections To A TV Or VCR
Allows high-speed search in either direction during video
playback.
1) During playback, press 5 for forward search, or
3 for reverse search.
2) To resume normal playback, press 4/9.
I During playback, press and hold 5 or 3. The search
continues as long as you hold the button. Once you release
the button, normal playback resumes.
I A slight mosaic effect appears on the display during Shuttle
Search. This is not a malfunction.
To AV connector
ATTENTION:
During Shuttle Search, parts of the Open the cover.
picture may not be clearly visible, S/AV/Editing cable mark
particularly on the left side of the (provided)
screen.
Blank Search
Helps you find where you should start recording in the 12345
middle of a tape to avoid time code interruption.
TV
( pg. 17)
1Load a cassette. (pg.14)
2Set the VIDEO/MEMORY Switch to ?VIDEO?.VCR
3Set the Power Switch to ?PLAY? while pressing down
the Lock Button located on the switch.
ARemote plug:Not connected (When not in use, keep
4Press MENU. The Menu Screen appears.the Remote plug in its protective caddy.)
5Press or to select ?t?, and press SET. The BBlack to S-VIDEO IN (Connect when your TV/VCR has
VIDEO Menu appears.S-VIDEO IN and A/V input connectors. In this case, it
is not necessary to connect the yellow video cable.)
6Press or to select ?BLANK SRCH?, and press
CYellow to VIDEO IN (Connect when your TV/VCR has
SET. The Sub Menu appears.
only A/V input connectors.)
7Press or to select ?EXECUTE?, and press SET.DRed to AUDIO R IN*
I The ?BLANK SEARCH? indication appears and the EWhite to AUDIO L IN*
camcorder automatically starts reverse or forward search, * Not required for watching still images only.
then stops at the spot which is about 3 seconds of tape
before the beginning of the detected blank portion.1Make sure all units are turned off.
I To cancel Blank Search midway, press 8.
2Connect the camcorder to a TV or VCR as shown in
NOTES:the illustration.
I Before starting Blank Search, if the current position is at a
If using a VCR, go to step 3.
blank portion, the camcorder searches in the reverse
If not, go to step 4.
direction. If the current position is at a recorded portion, the
camcorder searches in the forward direction.3Connect the VCR output to the TV input, referring to
I If the beginning or end of the tape is reached during Blank your VCR?s instruction manual.
Search, the camcorder stops automatically.
4Turn on the camcorder, the VCR and the TV.
I A blank portion which is shorter than 5 seconds of tape
may not be detected.5Set the VCR to its AUX input mode, and set the TV to
I The detected blank portion may be located between its VIDEO mode.
recorded scenes. Before you start recording, make sure
6Start playback on the camcorder. (pg.17)
there is no recorded scene after the blank portion. |
ACEC
