3135-125-21331 10/09/02 DFU LO1-2K2 CH1, HC, OCC, PC, PL, TL
IMPORTANT SAFETY INSTRUCTIONS
Read before operating equipment
1.Read these instructions.B. Objects have fallen, or liquid has been spilled into the appliance;
or
2.Keep these instructions.
C. The appliance has been exposed to rain; or
3.Heed all warnings.
D. The appliance does not appear to operate normally or exhibits a
4.Follow all instructions.
marked change in performance; or
5.Do not use this apparatus near water.E. The appliance has been dropped, or the enclosure damaged.
6.Clean only with a dry cloth.
17. Tilt/Stability - All televisions must comply with recommended inter-
7.Do not block any of the ventilation openings. Install in accordancenational global safety standards for tilt and stability properties of its
with the manufacturers instructions.cabinet design.
8.Do not install near any heat sources such as radiators, heat registers,? Do not compromise these design standards by applying excessive
stoves, or other apparatus (including amplifiers) that produce heat.pull force to the front, or top, of the cabinet which could ultimately
overturn the product.
9.Do not defeat the safety purpose of the polarized or grounding type
plug. A polarized plug has two blades with one wider than the other.? Also, do not endanger yourself, or children, by placing electronic
A grounding type plug has two blades and third grounding prong. Theequipment/toys on the top of the cabinet. Such items could unsuspect-
ingly fall from the top of the set and cause product damage and/or per-
wide blade or third prong are provided for your safety. When the pro-
sonal injury.
vided plug does not fit into your outlet, consult an electrician for
replacement of the obsolete outlet.18. Wall or Ceiling Mounting - The appliance should be mounted to a wall
or ceiling only as recommended by the manufacturer.
10. Protect the power cord from being walked on or pinched particularly
19. Power Lines - An outdoor antenna should be located away from power
at plugs, convenience receptacles, and the point where they exit from
lines.
the apparatus.
20. Outdoor Antenna Grounding - If an outside antenna is connected to
11. Only use attachments/accessories specified by the manufacturer.
the receiver, be sure the antenna system is grounded so as to provide
12.Use only with a cart, stand, tripod, bracket, or table speci-some protection against voltage surges and built up static charges.
fied by the manufacturer, or sold with the apparatus. WhenSection 810 of the National Electric Code, ANSI/NFPA No. 70-1984,
a cart is used, use caution when moving the cart/apparatusprovides information with respect to proper grounding of the mast and
combination to avoid injury from tip-over.supporting structure, grounding of the lead-in wire to an antenna dis-
charge unit, size of grounding connectors, location of antenna-dis-
13. Unplug this apparatus during lightning storms or when unused for
charge unit, connection to grounding electrodes, and requirements for
long periods of time.
the grounding electrode. See Figure below.
14. Refer all servicing to qualified service personnel. Servicing is
21. Object and Liquid Entry - Care should be taken so that objects do not
required when the apparatus has been damaged in any way, such as
fall and liquids are not spilled into the enclosure through openings.
power-supply cord or plug is damaged, liquid has been spilled or
objects have fallen into apparatus, the apparatus has been exposed to22. Battery Usage CAUTION - To prevent battery leakage that may result
in bodily injury, property damage, or damage to the unit:
rain or moisture, does not operate normally, or has been dropped.
? Install all batteries correctly, with + and - aligned as marked on the
15. This product may contain lead and mercury. Disposal of these materi-unit
als may be regulated due to environmental considerations. For dispos-? Do not mix batteries (old and new or carbon and alkaline, etc.)
al or recycling information, please contact your local authorities or the? Remove batteries when the unit is not used for a long time.
Electronic Industries Alliance: www.eiae.org Note to the CATV system installer: This reminder is provided to call the
16. Damage Requiring Service - The appliance should be serviced byCATV system installer's attention to Article 820-40 of the NEC that provides
qualified service personnel when:guidelines for proper grounding and, in particular, specifies that the cable
ground shall be connected to the grounding system of the building, as
A. The power supply cord or the plug has been damaged; or
close to the point of cable entry as practical.
ADDITIONAL NOTE FOR ?HC? MODELS
Installer: This product is not provided with a pendant control; how-
ever, it is expected that this institution (or hospital) will provide one
for attachment to the appropriate receptacle on the product. As part
of the installation, examine the pendant control to determine whether
a marking similar to the one below appears on it:
?CAUTION - Risk of fire if used in oxygen-enriched
atmosphere - return to hook or holder after use.?
If the above notice is not provided on the pendant control,
remove the label provided with these instructions and attach
it to the pendant control.? A separate adhesive-backed label stating
?CAUTION? ?Risk of fire if pendant control is used in oxygen-
enriched atmosphere. Keep pendant control away from oxygen
equipment,? can be affixed by the installer to the pendant control if
necessary.
This ?bolt of lightning? indicates uninsulated material within your unit which may cause an electrical shock.
Know theseFor the safety of everyone in your household, please do not remove product covering.
The ?exclamation point? calls attention to features for which you should read the enclosed literature closely to
safety symbols
prevent operating and maintenance problems.
WARNING: TO PREVENT FIRE OR SHOCK HAZARD, DO NOT EXPOSE THIS EQUIPMENT TO RAIN OR MOIS-
C A U T I O NTURE.
RISK OF ELECTRIC SHOCK
DO NOT OPENCAUTION: To prevent electric shock, match wide blade of plug to wide slot, and fully insert.
CAUTION: TO REDUCE THE RISK OF ELECTRIC
SHOCK, DO NOT REMOVE COVER (OR BACK). NOATTENTION: Pour éviter les chocs électriques, introduire la lame la plus large de la fiche dans la bome correspon-
USER SERVICEABLE PARTS INSIDE. REFER SER-dante de la prise et pousser jusqu?au fond.
VICING TO QUALIFIED SERVICE PERSONNEL.
2 |
ACEC
