Connecting
Y Insert the radio aerial lead supplied into the FM ANT
:FM ANTFM ANT.socket located at the bottom of the TV.
Y Use the aerial connection lead supplied and connect
the : socket situated at the bottom of the TV to
your aerial socket.
If you are using an indoor aerial,reception may be difficult in
certain conditions.You can improve reception by rotating the
aerial.If the reception remains poor,you will need to use an
:
external aerial
Y Connect the power lead to the television and the mains
plug into the wall socket (220-240 V/50 Hz).
Y Arrange the leads by passing them through the
television stand.
Connecting peripheral equipment
Video recorderVideo recorder (or DVD recorder)
Carry out the connections shown opposite, using a good
FM
:ANTEXT1quality euroconnector cable.
If your video recorder does not have a euroconnector socket,
the only connection possible is via the aerial cable.You will
therefore need to tune in your video recorder's test signal and
assign it programme number 0 (refer to manual store,p.6).To
reproduce the video recorder picture,press 0.
Video recorder with decoder
Connect the decoder to the second euroconnector
VCRsocket of the video recorder.You will then be able to
record scrambled transmissions.
Other equipmentSatellite receiver, decoder, DVD, games, etc.
Make the connections as shown opposite.
EXT1
Side connections
Make the connections as shown opposite.With the n key,
select EXT2/S-VHS2.
*For a monophonic device,connect the audio signal to the AUDIO
RL input.The sound automatically comes out of the left and right
Audio
inspeakers of the set.L
Video inHeadphones
S-VideoWhen headphones are connected,the sound on the TV set
will be cut.The @ P# keys are used to adjust the volume
level.
The headphone impedance must be between 32 and 600 Ohms.
4 |
ACEC
