Using the Remote Control
POWER
USINGTHE CODE-ENTRY METHODTO PROGRAM YOUR TV REMOTESWAPTVDNPIP CHUPVCRCONTROLACTIVEFREEZEACC
SOUNDPICTURE
ow that you have looked up the four-Satellite Receiver
Ndigit remote-control Direct-entry Code
for your brand of accessory device,you are
ready to follow the simple steps shown below
to program your TV remote.
Please read through all the steps before
beginning.Cable Converter Box
First, press and hold down the VCR
or ACC (for an accessory device
1
other than a VCR) mode button on
DVD Player
the TV remote. Then press and hold
down the MENU/SELECT button at
the same time for a brief moment.
Release the buttons. The TV remote
back light will switch on.
NOTE: For correct operation, you
VCRmust first press and hold the mode
button and then press and hold the
MENU/SELECT button simultaneously.
W ithin 30 seconds of pressing the
VCR (or ACC) button and
2
MENU/SELECT button, enter a
four-digit code for the accessory
device (see pages 21 and 22).
If you make a mistake while attempt-
ing to enter the four-digit code and
want to start again, press any button
POWER
other than one with a number. Then
return to step 1 to begin again.
1
Point the remote at the accessory
device.Then press the POWER button
3TVVCRACC3
on the remote to turn the device on.ACTIVE
SWAPPIP CHCONTROL FREEZE
DNUP
SOUNDPICTURE
1
STATUS/MENU/SELECT
EXIT
HELPFUL HINTS
MUTE
? If you do not enter a complete code within2
VOLCH
30 seconds, you will need to perform step
1 of the Code-entry Method again.
? If you enter more than four digits, the unit213
will retain the first four digits entered.
465
? If the procedure explained above does not
798
work the first time, repeat the steps usingTV/VCR
the same remote code number.A/CH0SURF
? If after a second try the remote does not
POSITIONPIP
operate your accessory device, and more
code numbers are listed for your brand,
use the next listed code number.
? If after repeated attempts the Entry-code
Method does not allow you to work your
accessory device with your TV remote, try
the Search Method explained on the next
page.
19 |
ACEC
