Record and Playback Your Performance
If you wish, you can erase the bass performance from the music files, and record your own
performance on the pedal keyboard. For details refer to ORe-recording the Pedalboard Perfor-MEMO
mance� (p. 53).
If the rhythm is played during recording, the performance data that was loaded into internal
memory will not play back.NOTE
7.Press the [Stop] button to stop recording.
Commercially sold music files can also be loaded into the AT-10S, but for reasons of copyright
protection, cannot be saved in SMF format.NOTE
Re-recording a performance
A song saved on floppy disk can be loaded into the AT-10S, and you can then re-record
the performances of the upper keyboard and lower keyboard.
1.Into the disk drive, insert the floppy disk that contains the perfor-
mance data.
2.Use the Select [-] [+] buttons to select the performance data that
you wish to load into internal memory, and press the [Load] button.
The selected performance data will be loaded into internal memory.
3.Make the panel settings that you wish to record.
4.Press the [Rec] button to enter record-ready mode.
The [Rec] button indicator will light, and the [Play] button indicator will blink.
5.Press the [Play] button to begin recording.
When you press the [Play] button, the metronome will play two measures (bars) of
count-in before recording begins.
The upper keyboard and lower keyboard performances of the loaded performance data
will be re-recorded.
The performance of the pedal keyboard will not be recorded at this time.
You can re-record the pedal keyboard performance. For details refer to ORe-recording the Pedal-
board Performance� (p. 53).MEMO
If the rhythm is played during recording, the performance data that was loaded into internal NOTE
memory will not play back.
6.Press the [Stop] button to stop recording.
47 |
ACEC
