ROLAND F-100 Instruction Manual

F-100.e.book 29 Z
8
?
?
?
??
?e
?
?xý~
Uxý9 V
?p
?
? 
Connecting to Audio Equipment
Read this chapter if you wish to connect the F-100 to an audio
NOTE
device.
By connecting the F-100 with an audio device, you can listen Once the connections have been completed, turn on power to
to the sound of the F-100 through the speakers of the audio your various devices in the order specified. By turning on
device, or record your performance onto a cassette tape or devices in the wrong order, you risk causing malfunction
and/or damage to speakers and other devices.
other recording media.
 Listening to the F-100 through the
About the Jacks
speakers of an audio device, or
fig.8-01recording a performance onto a
cassette tape or other media
fig.8-02
RL (Mono)RL (Mono)Input R/L
InputOutput
OutMIDIIn(Line In, Aux In)
Output Jacks
Use audio cables (sold separately) to connect the F-100 to an F-100
audio device so that the sound of the F-100 can be hear from
the speakers of the audio device, or so that your performance RL (Mono)RL (Mono)
InputOutput
can be recorded on a cassette tape or other recording media.OutMIDIIn
1.Turn on the power to the F-100.
Input Jacks
You can use audio cables (sold separately) to connect another 2.Turn on the power to the connected equipment.
audio producing device to the F-100, and hear its sound
3.Adjust the volume.
through the speakers of the F-100.
Recording procedure
Making the Connections
1.Start recording on the connected audio device.
2.Begin playing on the F-100.
NOTE
To prevent malfunction and/or damage to speakers or other 3.When you finish playing, stop recording.
devices, always turn down the volume, and turn off the
power on all devices before making any connections.
 Listening to the sound of an audio
device through the speakers of the
1.Turn the volume down completely on all
F-100
equipment.
fig.8-03
2.Turn off the F-100 and any other devices to be Output R/L
(Line Out)
connected.
3.Use audio cables (sold separately) to connect the
F-100
other device to the F-100.
NOTERL (Mono)RL (Mono)
InputOutputOutMIDIIn
If the device you are connecting is monaural, connect it to the
1.Turn on the power to the connected equipment.
L (Mono) jack. In this case, do not connect the R jack of the
F-100.
2.Turn on the power to the F-100.
NOTE
3.Adjust the volume.
Use a cable from Roland to make the connection. If using
some other make of connection cable, please note the NOTE
following precautions.
If the volume of any device connected to the Input jacks is
Some connection cables contain resistors. Do not use cables
raised too high, you not only risk causing damage to your
that incorporate resistors for connecting to this unit. The use
hearing, you could also damage the unitOs speakers. ItOs best
of such cables can cause the sound level to be extremely low,
to always keep the sound within reasonable levels of volume.
or impossible to hear. For information on cable specifications,
contact the manufacturer of the cable.
29