Editing Songs
Specifying the Area of a Song that Editing Sequencer Data Over
will Repeat (Loop Points)the Specified Range
When using Loop Play or Loop Recording, you can use the loop
(Track Edit)
points you specify here to specify the repeated area, as an alternative
to repeating the specified number of measures.Track Edit lets you edit areas of sequencer data that you specify.
If the song time signature is different than the pattern time Basic Operation for Track Editing
signature (pattern beat), the loop points will be displayed 1. Access the Song Edit screen, and then load the song you
differently in the song and pattern.want to edit (p. 136).
1. Load the song for which you want to set loop points (p. 136).
2. Access the Song Setup window (p. 137).If you want to edit the pattern, access the Pattern Edit screen by
selecting OPattern Edit� from the Menu window.
3. Useorto select OLoop,� and then press [8 (Select)].
fig.11-10.e
The Loop window appears.Pattern number
fig.11-09_50Indicates the name of the currently
Pattern name
selected song, the measure location,
Measure numberthe time signature, and the sequencer status.
Measures
containing no
sequencer data
4. Move the cursor to the desired parameter, and turn the Measures
containing
VALUE dial or press [INC]/[DEC] to make the setting.
sequencer data
Repeat
Select the number of repeats (1�99). If you want repetition to
continue until you press [STOP/PLAY], set this to OINFINIT.�
Start
Specify the location at which repetition is to begin.
Current location
Turns the RPS function on/off (RPS).
Turns Loop Play and Loop Recording
on/off (LOOP).
If you press [7 (Set)], the current location of the song will be set
Indicates/sets the songOs playback tempo.
as the starting location.
Editing Songs
EndIf you select a song that is stored on disk, a message of OThe
Specify the location at which repetition will end. The location you Song O****� is not Internal Song. Load anyway for Song Edit?�
specify here will not be included in the repeated area.will ask you for confirmation. If you want to erase the song from
the internal memory and load the new song, press [7 (OK)]. If
you decide not to erase the song from the internal memory, press
If you press [7 (Set)], the current location of the song will be set [EXIT].
as the ending location.
2. Press [8 (Track Edit)].
5. If you press [8 (Loop)] to assign a check mark ( ), looping
The Track Edit window appears.
will be turned on.fig.11-11_50
139 |
ACEC
