For EU Countries
The lightning flash with arrowhead symbol, within an
CAUTION
equilateral triangle, is intended to alert the user to the
RISK OF ELECTRIC SHOCK This product complies with the requirements of European Directives EMC 89/336/EEC and LVD 73/23/EEC.
DO NOT OPENpresence of uninsulated ?dangerous voltage? within the
product?s enclosure that may be of sufficient magnitude to
ATTENTION: RISQUE DE CHOC ELECTRIQUE NE PAS OUVRIR
constitute a risk of electric shock to persons.
For the USA
CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, The exclamation point within an equilateral triangle is
DO NOT REMOVE COVER (OR BACK). intended to alert the user to the presence of important FEDERAL COMMUNICATIONS COMMISSION
NO USER-SERVICEABLE PARTS INSIDE. operating and maintenance (servicing) instructions in the
literature accompanying the product.RADIO FREQUENCY INTERFERENCE STATEMENT
REFER SERVICING TO QUALIFIED SERVICE PERSONNEL.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the
FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee
INSTRUCTIONS PERTAINING TO A RISK OF FIRE, ELECTRIC SHOCK, OR INJURY TO PERSONS.that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
IMPORTANT SAFETY INSTRUCTIONS - Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
SAVE THESE INSTRUCTIONS
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
WARNING - When using electric products, basic precautions should always be followed, including the following:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that may cause undesired operation.
1. Read these instructions. 10. Protect the power cord from being walked on or pinched
Unauthorized changes or modification to this system can void the users authority to operate this equipment.
2. Keep these instructions. particularly at plugs, convenience receptacles, and the
This equipment requires shielded interface cables in order to meet FCC class B Limit.
3. Heed all warnings. point where they exit from the apparatus.
4. Follow all instructions. 11. Only use attachments/accessories specified by the
5. Do not use this apparatus near water. manufacturer. For Canada
6. Clean only with a dry cloth. 12. Never use with a cart, stand, tripod, bracket,
7. Do not block any of the ventilation openings. Install in or table except as specified by the NOTICE
accordance with the manufacturers instructions. manufacturer, or sold with the apparatus.
This Class B digital apparatus meets all requirements of the Canadian Interference-Causing Equipment Regulations.
8. Do not install near any heat sources such as radiators, When a cart is used, use caution when
heat registers, stoves, or other apparatus (including moving the cart/apparatus combination to
amplifiers) that produce heat. avoid injury from tip-over.
AVIS
9. Do not defeat the safety purpose of the polarized or 13. Unplug this apparatus during lightning storms or when
grounding-type plug. A polarized plug has two blades with unused for long periods of time. Cet appareil numérique de la classe B respecte toutes les exigences du Reglement sur le matériel brouilleur du Canada.
one wider than the other. A grounding type plug has two 14. Refer all servicing to qualified service personnel. Servicing
blades and a third grounding prong. The wide blade or the is required when the apparatus has been damaged in any
third prong are provided for your safety. When the provided way, such as power-supply cord or plug is damaged, liquid
plug does not fit into your outlet, consult an electrician for has been spilled or objects have fallen into the apparatus,
replacement of the obsolete outlet.the apparatus has been exposed to rain or moisture, does
not operate normally, or has been dropped.
For the U.K.
WARNING: THIS APPARATUS MUST BE EARTHED
IMPORTANT: THE WIRES IN THIS MAINS LEAD ARE COLOURED IN ACCORDANCE WITH THE FOLLOWING CODE.
GREEN-AND-YELLOW: EARTH, BLUE: NEUTRAL, BROWN: LIVE
As the colours of the wires in the mains lead of this apparatus may not correspond with the coloured markings identifying
the terminals in your plug, proceed as follows:
The wire which is coloured GREEN-AND-YELLOW must be connected to the terminal in the plug which is marked by the
letter E or by the safety earth symbol or coloured GREEN or GREEN-AND-YELLOW.
The wire which is coloured BLUE must be connected to the terminal which is marked with the letter N or coloured BLACK.
The wire which is coloured BROWN must be connected to the terminal which is marked with the letter L or coloured RED.
2 |
ACEC
