GK-3B_e.book 9 Z8 ???? ??e?? xý~
U xý9=?p?? Â
Attaching the GK-3B to the Bass
Attaching the Divided Pickup
There are two ways to attach the divided pickup.
IAttaching the Pickup with Double-IAttaching the Pickup with Screws (p. 12)
Sided Tape (p. 9)This method features the benefit of allowing
This provides the simplest way to attach thethe pickups to be finely adjusted later on, but
pickup to flat-top basses.it is somewhat difficult to carry out.
* Do not place any unnecessary strain on the cable connecting the pickup and the controller. This may result in breaking.
* Do not bend or twist the pickup. Use particular care when removing the pickup.
 Attaching the Pickup with Double-Sided Tape
1.You decide on the location in which to For a 5-string bass:
install the pickup.Attach the divided pickup so that the center
For a 4-string bass:marker is between strings 2 (D) and 3 (A),
Attach the divided pickup so that the centerthe 2nd string marker is directly below string
marker is between strings 2 (D) and 3 (A),1 (G), and the 5th string marker is directly
the 2nd string marker is directly below stringbelow string 4 (E).fig.1070e
1 (G), and the 5th string marker is directly54321 String
below string 4 (E).
(Viewed from above)
fig.1060ae
4321 String
* Depending on the GK-compatible device, it is
possible to install the pickup so that the center
marker is between strings 3 and 4. Refer to the
manual for your GK-compatible device.
For a 6-string bass:
(Viewed from the neck)Attach the divided pickup so that the center
fig.1060be
1234marker is between strings 3 (D) and 4 (A),
the 2nd string marker is directly below string
2 (G), and the 5th string marker is directly
2nd string marker5th string markerbelow string 5 (E).
fig.1080e
654321 String
* Depending on the GK-compatible device, it is
possible to install the pickup so that the center
marker is between strings 1 and 2, or between
strings 3 and 4. Refer to the manual for your GK-
compatible device.
9 |
ACEC
