Enter the set-up codes of the componentsUse the remote control within a range of about
respectively, referring to ?ENTERING A7 meters (23 feet) and angles of up to 30
ENGLISH
SET-UP CODE? (12page)degrees aiming at the remote sensor.
1
Turn on the components you want to
operate.
INPUT SELECTORMASTER VOLUME
2TAPE 2 MONITORTONE DIRECT
DIGITAL INPUTDYNAMIC RANGE
ON/OFFPOWERDTSDIGITALPRO-LOGICDSP MODESTEREO
STANDBYDOOR OPEN
Press the DEVICE button on the remote
control corresponding to the componentA/V TUNER PRE AMPLIFIER AVP-9080RDS
you want to operate.3
7m
3030
Press the button corresponding to the
operation you want while aiming the
4remote control at the REMOTE SENSOR
on the component.
When operating a Sherwood CD player or tape deck
using the system remote control, aim the remote
control at the REMOTE SENSOR on this unit.
When ?L-BAT? flickers on the LCD, the old batteries should be replaced.
When changing the batteries, load the new batteries within 10 sec. to maintain existing programming.
If the batteries are removed for a longer period of time, the remote control might lose its memory and require re-programming.
Remove the cover.Load 4 AAA 1.5V batteries matching the
polarity.
12 |
ACEC
