2. After the washer is level, use a 17 mm open-end wrench to
turn the nuts on the feet tightly against the washer cabinet.
Route the Drain HoseAll 4 feet must be tightened. If the nuts are not tight against
Proper routing of the drain hose protects your floors from
damage due to water leakage. Carefully read and follow these the washer cabinet, the washer may vibrate.
instructions.3. Slide the washer to its final location.
The drain hose is connected to your washer.4. Confirm the levelness of the washer.
Complete Installation
1. Check the electrical requirements. Be sure that you have the
correct electrical supply and the recommended grounding
method. (See ?Electrical Requirements.?)
2. Check to be sure all parts are now installed. If there is an
extra part, go back through the steps to see which step was
skipped.
3. Check to be sure you have all of your tools.
To prevent drain water from going back into the washer:
4. Dispose/recycle all packaging materials.
Do not straighten the drain hose, and do not force excess 5. Check to be sure the water faucets are on.
drain hose into standpipe. Hose should be secure, but loose 6. Check for leaks around faucets and inlet hoses.
enough to provide a gap for air.
Do not lay excess hose on the bottom of the laundry tub.
WARNING
Floor drain
You may need additional parts. (See Floor Drain under ?Alternate
Parts.?)
Secure the Drain Hose
1. Drape the power cord over the washer top.
2. Secure the drain hose to the laundry tub leg or standpipe with
the beaded strap provided. (See illustrations 1 and 2.)
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in
123
death, fire, or electrical shock.
If the washer faucets and the drain standpipe are recessed
(see illustration 3), put the hooked end of the drain hose in the 7. Plug into a grounded 3 prong outlet.
standpipe. Tightly wrap the beaded strap around the water
inlet hoses and the drain hose.8. Read ?Washer Use.?
9. To test and to clean your washer, measure 1D? the normal
Do not force excess drain hose into the standpipe.recommended amount of powdered or liquid High Efficiency
(HE) detergent. Pour the detergent into the detergent
dispenser. Select NORMAL, and then select HOLD TO
Level the WasherSTART. Allow the washer to complete one whole cycle.
Properly leveling your washer prevents excessive noise and
vibration.
1. Check the levelness of the washer by placing a level on the
top edge of the washer, first side to side, then front to back.
If the washer is against a wall, move the washer out slightly
before tipping back. If the washer is not level, first prop the
front with a wood block (2" x 4") and adjust the feet as
necessary; then prop the back and adjust feet as necessary.
Repeat this step until washer is level.
8 |
ACEC
