124970982.qxd 9/4/01 2:49 AM Pagina 12 (Nero/Process Black pellicola)
12. How to change a programmeAfter approximately 3 minutes, you can open the door.
during its cyclePay attention to the level and temperature of the
water in the washing machine!
Before you make any change, you must pause the
washing machine by pressing the START/PAUSEWhen you close the door and press the ON/OFF button
button.again, the washing machine will resume the programme
from the point where it had been interrupted.
It is possible to change any phase before the programme
carries it out.
Changing the type of fabric or temperature is possible,15. End of programme
obviously, only during the washing phase. When you
At the end of the programme, the washing machine
make a change in these two parameters, the washingstops automatically, gives an audible signal, and displays
machine will resume the cycle from the beginning.
a blinking zero.
If it is necessary to drain the water in order to change theIf you had selected the RINSE HOLD option, the
programme in progress, proceed as follows:START/PAUSE button light flashes to indicate that the
PAUSE the machine by pressing the START/PAUSEwater must be drained. The display shows a steadily lit
button;zero.
press the SKIP/RESET button repeatedly, until only When the programme has been completed, a blinking
the DRAIN light remains lit;zero appears on the display and the audible signal is
press the START/PAUSE button again.given.
When the water has been drained, the display shows aThe DOOR LOCKED light goes out at once.
blinking zero. You may now select a new programmePress the SKIP/RESET button repeatedly to erase
and press the START/PAUSE button to start it.the programme that has just been carried out. If you
omit to do this, the next time you switch the washing
machine on, the blinking zero will appear on the
13. How to cancel a programmedisplay and you will hear the audible signal.
during its cycleNote: when you switch the machine on, if you must
To cancel a programme that is being carried out, firsterase the previously performed programme, it is also
pause the washing machine by pressing thesufficient to press the FABRIC button and select a new
START/PAUSE button, then press the SKIP/RESETprogramme.
button repeatedly, until the display shows three blinkingPress the ON/OFF button to switch the machine off. The
dashes.relevant light will go out.
Remove the laundry from the washing machine.
14. How to open the door duringCheck whether the drum is completely empty, by
rotating it with your hand. The purpose of this is to
the cycle of a programme
prevent any items of laundry from remaining
You can open the door, after having set the washingaccidentally in the drum, where they might get damaged
machine to PAUSE, provided the following conditionsin a subsequent wash (e.g. by shrinking) or bleed colour
exist:
into another load of laundry.
the washing machine is not in the heating phaseWe advise you to close the water supply tap and
beyond 40°C;disconnect the plug from the socket.
the level of the water is not high;Leave the door ajar in order to air the washing machine.
the drum is not turning.
If these requirements are met, when you pause the
washing machine, the DOOR LOCKED light goes out
and the door can be opened.
Should it not be possible to open the door, and should it
be absolutely necessary to do so, switch the machine off
by pressing the ON/OFF button.
12 |
ACEC
