DV-505, DVL-909, DV-S9
Special Mention Item
(1) Indications for the spindle status are as follows:(4) If you turn the power on while short-circuiting the short-circuit
A/B : Spindle accelerator and braketerminal at the side of the system controller, the player will
FG : FG servoforcibly enter the test mode. If the FL controller is set to Checker
SRV : Rough, velocity/phase servomode, disc sensing will not be started, even if a disc is loaded.
O_S : Offset addition, rough, velocity/phase servoDisc sensing will also not be performed if the tray is opend/
closed by your pressing [REPEAT A] key while in Checker
(2) The movement of loading in/out starts from the tray open status.mode.
After that, this function is executed unless a play and closeHowever, disc sensing will be started if the [OPEN/CLOSE]
operation are done.key on the player or on the remote control unit is pressed.
(3) There are three methods for entering a search address:(5) If disc-type designation is forcibly executed during a mode other
Absolute address designationthan Checker mode, the system controller will abandon disc-
? Searching for the address entered (indication for the mosttype designation after setting the mechanism controller.
significant digit :>)Therefore, after startup of the player, disc sensing will be
Additional inputperformed again for safety.
? Searching for the address with the current ID number plusIf disc-type designation is forcibly executed during Checker
an entered numbermode, as disc-type designation is not abandoned, playback will
(indication for the most significant digit :+)be immediately started.
Subtractive input
? Searching for the address with the current ID number minus(6) A background color change in order of blue ? green ? light
an entered number(indication for the most significant digit :�)blue ? red ? purple ? yellow ? gray ? black ? with the [2/
The above modes can be changed by pressing [10] key.R] key.
Note : A number for addition or subtraction must be entered inIt changes in order of gray ? yellow ? purple ? red ? light
hexadecimal.blue ? green ? blue ? black ? in the case of the [1/L] key.
(7) In case of PD0260A*, tilt servo on function may not move with
DVD.
3.7 Test Mode Screen Display (The Second Generation)
Consecutive double-OSD display is supported during test mode. The screen is composed 10 lines with a maximum of 32 characters per line.
It can't be used with the debugging display mode together.
Y Screen Composition
Character in bold : Item name
: Information display Remote control code
Address Key code
Tilt error value, Tilt servo status Mechanical position value
Tracking status Slider position
Spindle status Output video system
AV1 classification and
AGC setting
Flash ROM size
FL controller version
FTS servo IC information Region setting for the player
C1 error value of CD and DVD Flash ROM version
Internal operation mode of System controller revision
the mechanism control
Disc judgment DVD mechanism controller revision
Pickup AV-1 chip version
CLD mechanism controller revision
First screen display
Caution :
The first screen and second screen switch by
pressing [DISPLAY] key of the remote control FL controller version
unit.
GUI-ROM number
It is only a version display part on the lower
Part No. of flash ROM and system controller
right of the screen those contents of display
change. Part No. of DVD mechanism controller
ATB : ON/OFF information display and AGC Part No. of CLD mechanism controller
manual establishment display deleted with the
second generation.
Second screen display (at lower right portion of the screen)
17 |
ACEC
