1-5. Replacement of Chassis Fans
1-5-5. Replacement of Rear Fan
(92xxxxx92 mm)
5. Remove the two screws of the fan, then replace the fan1. Remove the right side panel of the power case.
with new one.(Refer to step 1 in Section 1-5-3.)
2. Open the upper panel of the power case.
(Refer to steps 2 and 3 in Section 1-5-3.)
3. Make sure that the fan harness is routed in the back of
the hexagonal spacer.
4. Remove the fan harness from connector CN12.
FanFan harness
CN12
Hexagonal spacer6. Install the new fan in the reverse order of step1 to step
5.
n
This fan is used to suck in air. Be sure to attach the
new fan with the yellow label side inside.5. Remove the seven screws, then remove the fan and
finger guard.
Yellow label
Fan
InsideFan
Finger guard
7. After the fan replacement, make sure the fan operation.
(Refer to Section 1-5-2.)6. Place the finger guard on a new fan.
7. Install the new fan in the reverse order of step 1 to step 5.
8. After the fan replacement, make sure the fan operation.
(Refer to Section 1-5-2.)
1-16 (E)MAV-1000 |