Users in Canada
PRE-INSTALLATION REQUIREMENTS FOR CANON FACSIMILE EQUIPMENT
A.Location
Supply a suitable table, cabinet, or desk. See specifications (p. 103) for unitOs dimensions and weight.
B.Order Information
1.Provide only a single line to touch-tone or rotary telephone set terminated with a standard 4-pin
modular phone plug. (Touch-tone is recommended if available in your area.)
2.Order an RJ11-C modular jack (USOC code), which should be installed by the phone company. If
the RJ11-C jack is not present, installation cannot occur.
3.Order a normal business line from your telephone companyOs business representative. The line
should be a regular voice grade line or equivalent. Use one line per unit.
DDD (DIRECT DISTANCE DIAL) LINE
or
IDDD (INTERNATIONAL DIRECT DISTANCE DIAL) LINE IF YOU
COMMUNICATE OVERSEAS
NOTE: Canon recommends an individual line following industry standards [e.g., the 2500 (Touch tone)
or 500 (Rotary/Pulse Dial) telephones]. A dedicated extension off a PBX unit without OCamp
On� signals is also permissible with a FAX unit. Key telephone systems are not recommended
because they send non-standard signals to individual telephones for ringing and special
codes, which may cause a FAX error.
C.Power Requirements
The power outlet should be a three-prong grounded receptacle (Single or Duplex). It should be
independent from copiers, heaters, air conditioners, or any electric equipment that is thermostatically
controlled. The rated value is 120 volts and 15 amperes. The RJ11-C modular jack should be relatively
close to the power outlet to facilitate installation.
NOTICE
The Industry Canada label identifies certified equipment. This certification means that the equipment meets
telecommunications network protective, operational and safety requirements as prescribed in the appropriate
Terminal Equipment Technical Requirements document(s). The Department does not guarantee the
equipment will operate to the userOs satisfaction.
Before installing this equipment, users should ensure that it is permissible to be connected to the facilities of
the local telecommunications company. The equipment must also be installed using an acceptable method of
connection. The customer should be aware that compliance with the above conditions may not prevent
degradation of service in some situations.
Repairs to certified equipment should be coordinated by a representative designated by the supplier. Any
repairs or alterations made by the user to this equipment, or equipment malfunctions, may give the
telecommunications company cause to request the user to disconnect the equipment. Information regarding
authorized service facility locations can be obtained by calling Canon Canada below.
CANON CANADA
1-800-263-1121
24 HOURS A DAY, 7 DAYS A WEEK
Users should ensure for their own protection that the electrical ground connection's power utility, telephone
lines and internal metallic water pipe system, if present, are connected together. This precaution may be
particularly important in rural areas.
Caution
Users should not attempt to make such connections themselves, but should contact the appropriate electric
inspection authority, or electrician, as appropriate.
NOTICE
The Ringer Equivalence Number (REN) assigned to each terminal device provides an indication of the
maximum number of terminals allowed to be connected to a telephone interface. The termination on an
interface may consist of any combination of devices subject only to the requirement that the sum of the Ringer
Equivalence Numbers of all the devices does not exceed 5.
vii |
ACEC
