LINE CORD
Your amplifier is equipped with a grounding type supply cord to reduce the possibility of shock due to electrical fault. Be sure to
connect it to a grounded receptacle. Operation from an ungrounded (two-pronged) AC receptacle requires a three-to-two
contact grounding type adapter. Be sure to connect the adapterOs grounding lead to a good earth ground. DO NOT ALTER THE
AC PLUG.
TUBES
The �65 TWIN REVERB tube complement consists of four Fender Special Design 6L6GCs (part number 023556), four Fender
Special Design 12AX7As (part number 013341), and two Fender Special Design 12AT7s (part number 023531). FenderOs
Special Design Tubes provide optimum performance in this amplifier. For best results, replace with Fender original equipment
tubes only. Tube location is printed on the tube label, inside the cabinet.
BLACK TOLEX COVERING CARE
The exclusive Fender Tolex covering on your cabinet is especially designed to provide years of lasting beauty. A very light soapy
solution on a sponge may be used to remove dirt and residue that may accumulate in the grain. Be careful not to let any liquid
come in contact with operating surfaces. DO NOT have the amplifier plugged into a power outlet when cleaning.
TROUBLESHOOTEROS CHECKLIST
If the amp is set up but does not function, check the following items:
- Is the amp power cord properly plugged into an electrical outlet?
- Is there power at the outlet?
- Is the fuse blown?
- Are the speakers properly connected to the amplifier?
- Is the amp on standby?
- Are the amplifier volume and tone controls turned up above Othree�?
- Is the volume control on the instrument turned up?
- Is your instrument properly plugged into the amplifier?
(Eliminate any effects pedals and try another guitar cord.)
If, after checking all of the above, the system is not performing correctly, consult your Fender Service Center.
�65 TWIN REVERB SPECIFICATIONS
PART NUMBER: 21- 7300.
DIMENSIONS: HEIGHT: 19-7/8� (49.2 cm).
WIDTH: 26-5/32� (63.5 cm).
DEPTH: 10-3/8� (21.9 cm).
WEIGHT:64 lb. (29 kg).
POWER OUTPUT: 85 watts R.M.S. minimum into 4 ohms.
OUTPUT IMPEDANCE: 4 ohms.
INPUT IMPEDANCE: Input 1, both channels: 1M ohms.
Input 2, both channels: 136k ohms.
FEATURES: Vibrato and Reverb, Tilt-back legs.
POWER REQUIREMENTS: 120 volts AC, 60 Hz, 2.17 amperes, 260 watts.
FUSE TYPE: 4 ampere, slow-blow, 125 volt minimum.
SPEAKER COMPLIMENT: (2) P/N 037617 12� Fender vintage re-issue speakers,
designed to match the OSpecial Design� speakers of the mid 1960s.
SOUND: Legendary, and loud!
A PRODUCT OF:
FENDER MUSICAL INSTRUMENTS CORP.,
BREA, CA 92621 |
ACEC
