Speaker Setup Guide
Chapter 2
Speaker Setup Guide
1 Attach the speaker stand bases to the stems
using the screws provided.
Safety precautions when setting upOnce you have aligned the stem and base, secure with
When assembling the speakers, lay them down flat on
their side to avoid accidents or injury. Make sure to use a the small screws at the points shown below. Note that
the speaker should face in the direction of the base of the
stable surface when assembling, setting up, and placing isosceles triangle (outlined below).
the speakers.
Home theater sound setup
This is a standard multichannel surround sound
speaker setup for optimal 5.1 channel home theater
sound.
Rear
FrontFront
leftright
Center Receiver subwooferFront
2 Attach the smaller non-skid pads to the base of
the center speaker. The large non-skid pads are for
the front and surround speakers, and the receiver
subwoofer (as shown).
Use the adhesive side of the pads to attach them to the
Listening position
SurroundSurroundbase (flat surface) of each speaker.
leftright
5
En |