42003bGB.FM5 Page 8 Wednesday, September 6, 2000 6:43 PM
TROUBLESHOOTING GUIDE
1. The red LED remains lit.5. Compressor runs continuously.
Defrosting in progress?Have hot foods been put in the freezer?
Contents impeding correct closure of thHae s the freezer lid been open for a long
freezer lid?time?
Appliance too near a source of heat?Is the appliance located in a room which is
Is the thermostat setting correct?too hot or too close to a source of heat?
Are the ventilation grille and condenser Is the thermostat setting correct?
clean?Rapid freeze button pressed inadvertently?
2. Appliance is excessivelly noisy.6. Too much ice on the upper edge.
Is the appliance level?Are the defrost water drainage plugs
Is the appliance in contact with other correctly positioned?
fixtures or items that could give rise tIs tho e lid correctly closed?
vibration?Is the appliance lid seal damaged or
Has the packaging been removed from deformed?
under the freezer?(See chapte?Inr stalla?tion).
Note:Gurgling noises from the refrigeratHaingve the 4 protection pieces been
removed?
circuit after the compressor cuts out are
(See chapte?Inr stalla?tion).
perfectly normal.
7. Formation of condensation on the
3. The green light is off and the appliance is
external walls of the freezer.
not working.
It is normal for condensation to form under
Is there a power failure?
certain atmospheric conditions (humidity
Is the plug properly inserted in the socket?
above 85%) or if the appliance is located in
Is the electric cable intact?a damp or poorly ventilated room. The
4. The green light is off and the appliance perfois rmance of the freezer is in no way
affected.
working.
The green light is not working. Conta8.ct AfThe layer of ter ice on the internal walls of the
Sales Service for a replacement.freezer is not uniform.
This phenomenon is quite normal.
AFTER-SALES SERVICE
Before contacting After-Sales Servicethe Service number
(the number after the word
1. See if you can solve the problem yourself
SERVICE on the data plate
with the help of th?Troue bleshooting gu?).ide
on the rear of the
2. Switch the appliance on again to see if the
appliance),
problem has been solved. If it has not,
your full address,
disconnect the appliance from the power
supply and wait for about an hour beforeyo ur telephone number and
switching on again.area code.
3. If the problem persists, contact After Sales
Service.
Specify:
the nature of the problem,
the model,
8 |
ACEC
