75195.fm5 Page 6 Wednesday, October 25, 2000 10:48 AM
HOO 521-531PRODUCT SHEET
THE CONTROL PANEL
A. Light switch.
B. Speed selector switch.
C. Extraction speed indicator.
small amount of steam
1. Control panellarge amount of and fumes
2. Grease filters (behind the extractor grille)steam and
medium amount of
3. Lighting unitfumes
steam and fumes
4. Pull-out steam deflector
Removing and renewing or cleaning the
grease filter:
1. Unplug the appliance or disconnect the mains
power supply.
2. Pull out the steam deflector.
3. Open the extractor grille (Fig. A).
4. Remove the device securing the grease filter
(Fig. B).
5. Remove the dirty grease filter.
6. After the grease filter has been replaced or
cleaned (depending on model), refit the parts
in reverse order, making sure the entire
extraction surface is covered.
Fig. A
Fitting or renewing the carbon filter:
1. Unplug the appliance or disconnect the mains
power supply.
2. Pull out the steam deflector.
3. Open the extractor grille (Fig. A).
4. If the carbon filter is already fitted and needs
renewing, press the release b(b) and uttons
pull the filter out downward(Fig. C).s
5. If the filters are not fitted:
- Locate the carbon filter on the back
rings(a);
- secure the filter in front w(b)i th the clips
supplied with it.
Fig. B
6. Refit the extractor grille.
Replacing bulbs
1. Unplug the appliance or disconnect the mains
power supply.
2. Pull out the steam deflector.
3. Open the extractor grille.
4. Remove the burnt-out bulb.
Replace using 40W max (E14) bulbs only.
5. Refit the extractor grille.
Fig. C
D GBFNLEPI GRS
5019 100 75195NDK FIN |
ACEC
WHIRLPOOL
