Before use
Before using your dishwasher for the first time:
+ensure that the electrical and water
connections comply with the installation
instructions
+remove all packaging from inside the appliance
+set the water softener
+fill the salt container
+fill the rinse aid dispenser.
Setting the water softener
The dishwasher is equipped with a water softener
designed to remove minerals and salts from the water
supply, which would have a detrimental or adverse
effect on the operation of the appliance.
The higher the content of these salts, the harder your
water is.W ater
W ater hardness is measured in equivalent scales, ClarkehardnessW aterAdjustment
degrees and French degrees.Clarke FrenchLevelsofteneron the
degreesdegreesadjustment machine
The softener should be adjusted according to the
hardness of the water in your area. Your local W ater0 - 10 0 - 14 1NONO
15 - 3911 - 272NO
Authority can advise you on the hardness of the water in*NO
28 - 35 40 - 50 3YESNO
your area.
36 - 49 51 - 70 4NOYES
The dishwasher is factory set at level 2.
50 - 63 71 - 90 5YESYES
If this level is not suitable for your area the softener
should be adjusted.
* factory setting
+To adjust the water softener:
Level 1
If your water is "level 1" it is already soft and therefore
there is no need to use salt.
Levels 3 and 5
(water softener adjustment)
If your water is level 3 or 5, proceed as follows:
- slide out the lower basket and unscrew the cap of the
salt container;AA01
- turn the two-position selector anticlockwise from
position - to position + with the aid of a blunt knife or
screwdriver.
Levels 4 and 5
A
(adjustment on the machine)
If your water is level 4 or 5, open the door and drill
membrane (A) on the upper left-hand corner of the
machine.
W ith a water hardness of level 5 both adjustments must
be made.
AA04
6PBU01UK |
ACEC
PRIVILEG
