Start the tool before applying to work and let the 3. Insert three fourths of shank of accessory
tool come to full speed before contacting the into the collet, and securely tighten with the
workpiece. Lift the tool from the work before wrench provided.
releasing the switch. DO NOT turn the switch
Removing Accessories
?ON? and ?OFF? while the tool is under load;
this will greatly decrease the switch life.Repeat steps 1 and 2 of above and remove
accessory.
Grinding Wheels
WARNING! Before using a grinding wheel, Guard Installation (Model 1214 only)
be certain that its maximum safe operating 1. Loosen guard mounting strap nuts 10, and the
speed is not exceeded by the nameplate speed
wing nuts 7 on guard cover 8.
of the grinder. Do not exceed the recommended
2. Place wheel guard 9 over spindle and positon
wheel diameter.
guard mounting strap on lip of the machined
Grinding wheels should be carefully selected
spindle housing.
in order to use the grinder most efficiently.
3. Rotate guard 9 into position where maximum
Wheels vary in type of abrasive, bond, hardness,
protection is provided for the operator from
grit size and structure. The correct type of
wheel to use is determined by the job.spark and debris, then tighten mounting strap
nuts 10.
Installing Accessories
CAUTION! Be sure that the diameter of the7
shank is the same size as the inside diameter of
the collet.
Models 1209, 1210 & 1215 are equipped with8
a 1/4" collet.
(Models 1209 & 1215)
GRINDING
1. Place the (22mm) spindle lock wrench that is
WHEEL
provided onto the spindle to prevent the spindle
from rotating.
2. Hold wrench in place and rotate collet nut 1Installing Grinding Wheel
counter-clockwise with the (14mm) wrench( Model 1214 only)
that is provided.Your tool uses grinding wheels 5" maximum
3. Insert three fourths of shank of accessory diameter by 1" thick.
into the collet, and securely tighten with the 1. Insert the locking pin into the hole in the inner
wrench provided.flange 11 to prevent the spindle shaft from
NOTE: When replacing collets on the model rotating.
1215, loosen the collet nut and remove together 2. Hold locking pin in place and rotate nut 13
with collet 6, then screw in new collet.counter-clockwise with an open end wrench
and remove nut 13 and outer flange 12.
Removing Accessories
Repeat steps 1 and 2 of above and remove
9
accessory.
12
10
Installing Accessories
(Model 1210)
1. Insert the locking pin provided into hole in
the spindle, to prevent the spindle from rotating.
2. Hold locking pin in place and rotate collet nut
11
13
1 counter-clockwise with the (14mm) wrench
that is provided.
7
BM 3609929341 12/03712/16/03, 11:40 AM |
ACEC
BOSCH
