BM 2610967913 9/03 9/26/03 4:56 PM Page 8
TRACKING ADJUSTMENT
Turn sander upside down and plug it into theTRACKING
ADJUSTMENT KNOB
power source. Hold the sander firmly with one
hand, engage trigger switch to turn the tool
OON�, and note the tracking of the sanding
belt. If the belt runs outward (towards the
open side of the sander) turn tracking
adjustment knob counter-clockwise. If the belt
runs inward, turn the knob clockwise. Adjust
the belt in this manner until the edge of the belt
runs flush with the outer edge of both pulleys
and covers the platen protector. Your sander is
now ready for use. In some cases, the belt will
require a slight readjustment after it is applied
to the work surface, so note the tracking
carefully during the first minutes of operation
and readjust as required.
ADJUSTABLE TOP HANDLE bag makes contact with the static clip as
The top handle provided should always beshown. The static clip is provided to dissipate
used to guide and balance the tool. Grip thestatic electricity that accumulates in the bag
tool by the multi-position top handle, and theand can cause annoying shock to the user.
rear handle, for safe control and ease of
For added efficiency, a vacuum hose and
operation. To adjust the top handle, loosenadaptor (optional accessories) are also
wing knob at least two full turns, position
available which will allow your sander to be
handle and retighten knob firmly.connected to a shop vacuum system. See
DUST EXTRACTIONyour Bosch catalog for optional Bosch
Airsweep accessories.
Proper dust removal will extend abrasive life
and produce more consistent results. The
METALDUST BAG
integral dust extraction system collects
sanding dust in the dust bag assembly. BagFLANGE
should be emptied when it is no more than half
full, and should be replaced when the surface
becomes clogged with dust or efficiency will
be reduced. To empty or replace bag, pull the
bag free of dust port. Open the zipper on the
rear of the bag, and empty contents into
suitable receptacle.
To install bag, firmly push the bag into placeSTATIC
on the dust port so that it covers the "O" ringCLIP
to create a seal and the metal flange on dust
Sanding TipsOopen coat� will not clog or fill as readily as
Oclosed coat�. In general, aluminum oxide
SELECTING THE SANDING BELTabrasive belts are best for woodworking
It is very important that you select the properbecause they are tougher and last longer.
belt for each particular application. To do thisSanding belts should be stored in a cool, dry
you should understand the method of markingplace. Do not store near heat or near a window
or coding on the back of most belts. OCLOSEDwhere the sun can reach them.
COAT� means the surface is densely covered
TECHNIQUE
with as much grit as the adhesive will hold.
OOPEN COAT� means the grit has beenGrasp the handles firmly. Start the sander with
the belt off the work (NOTE: never start or stop
applied evenly, but openly to the surface. An
-8- |