Do not use tool if switch does not turn itcaused by poorly maintained tools. Develop a
OON� or OOFF�. Any tool that cannot beperiodic maintenance schedule for your tool.
controlled with the switch is dangerous and
Use only accessories that are
must be repaired.recommended by the manufacturer for
Disconnect the plug from the power sourceyour model. Accessories that may be suitable
before making any adjustments, changingfor one tool, may become hazardous when
accessories, or storing the tool. Suchused on another tool.
preventive safety measures reduce the risk of
starting the tool accidentally.Service
Store idle tools out of reach of children andTool service must be performed only by
qualified repair personnel. Service or
other untrained persons. Tools are
dangerous in the hands of untrained users.maintenance performed by unqualified
personnel could result in a risk of injury. For
Maintain tools with care. Keep cutting tools
example: internal wires may be misplaced or
sharp and clean. Properly maintained tools,pinched, safety guard return springs may be
with sharp cutting edges are less likely to bindimproperly mounted.
and are easier to control. Any alteration orWhen servicing a tool, use only identical
modification is a misuse and may result in a
dangerous condition.replacement parts. Follow instructions in
the Maintenance section of this manual.
Check for misalignment or binding of
Use of unauthorized parts or failure to follow
moving parts, breakage of parts, and anyMaintenance Instructions may create a risk of
other condition that may affect the toolselectric shock or injury. Certain cleaning
operation. If damaged, have the toolagents such as gasoline, carbon tetrachloride,
serviced before using. Many accidents are
ammonia, etc. may damage plastic parts.
Safety Rules for Orbital Sanders
Unplug the sander before changingentering the motor housing is an electrical
accessories. Accidental start-ups mayshock hazard.
occur if sander is plugged in while changingDo not use sandpaper intended for larger
an accessory. sanding pads. Larger sandpaper will extend
If your tool is equipped with a dust bag,beyond the sanding pad causing snagging,
empty it frequently and after completiontearing of the paper or kick-back. Extra
of sanding. Be extremely careful of dustpaper extending beyond the sanding pad
disposal, materials in fine particle form maycan also cause serious lacerations.
be explosive. Do not throw sanding dust onSome dust created by
an open fire. Spontaneous combustion, may!WARNING
power sanding, sawing,
in time, result from mixture of oil or watergrinding, drilling, and other construction
with dust particles.
activities contains chemicals known to
Always wear eye protection and a dustcause cancer, birth defects or other
mask for dusty applications and whenreproductive harm. Some examples of
sanding overhead. Sanding particles canthese chemicals are:
be absorbed by your eyes and inhaled easilyY Lead from lead-based paints,
and may cause health complications.
Y Crystalline silica from bricks and cement
Use special precautions when sanding
chemically pressure treated lumber, paintand other masonry products, and
that may be lead based, or any otherY Arsenic and chromium from chemically-
materials that may contain carcinogens. Atreated lumber.
suitable breathing respirator and protectiveYour risk from these exposures varies,
clothing must be worn by all personsdepending on how often you do this type of
entering the work area. Work area should bework. To reduce your exposure to these
sealed by plastic sheeting and persons notchemicals: work in a well ventilated area,
protected should be kept out until work areaand work with approved safety equipment,
is thoroughly cleaned.such as those dust masks that are specially
Do not wet sand with this sander. Liquidsdesigned to filter out microscopic particles.
-3- |
ACEC
BOSCH
