BM 2610914126 9-03 10/1/03 10:31 AM Page 8
NOTE: If you notice steadily increasing no-
load speed, this indicates that the damper ring
is worn and needs to be replaced.BACKING
PAD
To replace damper ring, remove backing pad
as described in OBacking Pad Installation� andDAMPER RING
remove worn damper ring by pulling firmly out
of locating groove. Loosen the two screws on
shroud just enough so you can separate
shroud approximately 1/4 inch. Align locatingSHROUD
bumps on damper ring with cut outs in shroud
and depress ring with thumbs until shroudLOCATING
BUMPS ON
seats into groove completely around ring, thenUNDERSIDE
tighten screws.
OF DAMPER
IMPORTANT: Ring should not have bends orRING
ripples when correctly seated.
Apply a thin film of light grease to top side of
backing pad where the damper ring makes
contact, reassemble backing pad and firmly
tighten screw.
INSTALLING ACCESSORIES
(Model 1295D 1295DH & 1295DVS)DUST COLLECTION CANISTER
Your random orbit sander uses hook-and-loopThe integral dust extraction system collects
backed accessories, which firmly grip the padsanding dust in canister supplied with your
when applied with moderate pressure. Tosander. For maximum efficiency, the dust
change the accessory, merely peel off the oldcanister should be emptied frequently during
accessory, remove dust from the pad ifoperation.
necessary, and press the new accessory inWhen the canister is removed from the tool an
place. Be sure to align the sanding disc holes
(optional vacuum hose accessory) can be
with the holes in the backing pad to allow theattached to the dust port.
dust extraction system to function.
After considerable service the pad surface willTo use this feature, attach vacuum adapter
become worn, and the pad must be replacedand vacuum hose (optional accessories) to
dust port, then connect opposite end of the
when it no longer offers a firm grip. If you are
experiencing premature wearout of the padvacuum hose to a shop vacuum cleaner.
facing, decrease the amount of pressure youCLEANING AND EMPTYING
are applying during operation of the tool.THE DUST CANISTER
(Model 1295DP only)To empty, lift lid of canister. Knock excess
Your sander is equipped with PSA backeddust out of the micro filter, or remove dust
accessories with pressure sensitive adhesive.with your fingers or a soft brush.
To change accessory, peel protective sheetYou may notice that all the dust may not come
from the back of accessory. Align accessoryout of the canister. This will not affect sanding
with backing pad and press firmly in place. Toperformance but will reduce dust collection
remove, lift an edge of accessory with yourefficiency.
finger nail and peel it off the backing pad.
NOTE: Do not wash the micro filter with soap
NOTE: Do not store tool with sanding disc onand water. Dust may become more firmly
pad, as sanding creates heat which increaseslodged in the pores, which will reduce dust
the adhesive bond. If the disc is left in place itcollection, and damage the micro filter.
may become very difficult to remove.
-8- |
ACEC
BOSCH
