Project Array OM 1/10/06 12:21 PM Page 6
1400 ARRAY ASSEMBLY
Due to the weight of the 5. Notice the two threaded10. Once both bolts have been
1400 Array horn module, it inserts on the angled face started, work them in all of
is packed separately from of the top and also the smallthe way, but do not tighten
the low-frequency enclosure.L-bracket on the top. Thesethem securely just yet.
It is a very simple procedure are the attachment points
11. Install the remaining short
to install the module, and thefor the horn module. Imme-bolt in the hole at the
necessary instructions arediately adjacent to the L-
bottom rear of the horn
listed below. The requiredbracket is a recessed con-module. You can fully
Allen-tipped screw driver isnector which will make the
tighten this bolt.
included in the accessoryelectrical connection for the
pack.horn module.12. Now completely tighten the
two front bolts.
1. Carefully remove the horn6. Although the module can
13. Everything should be tight
module from the packagingbe installed by one person,
and place it face down on ait is easier if a second set and properly aligned at this
soft surface.of hands are available.time. If not, loosen, realign,
and retighten as required.
2. Locate the cardboard7. Cradle the horn module with
accessory sleeve andthe opening along your fore-14. The final steps are to
remove the hardware.arm and, using your freeremove the backing from
hand, connect the plugthe logo badge and place it
3. The accessory sleeve
should contain:coming from the bottom ofin the recess on the lower
the horn assembly into thehorn lip, and to use the
a. 2 Long 1/4" x 20 Allen-rubber hole plug to hide the
jack on the top of the
head boltsenclosure.hole at the bottom rear of
the horn module. Do not
b. 1 Short 1/4" x 20 Allen-8. You can now place the horn
head boltcomplete these steps until
in position on top of thethe system has been turned
c. 1 Logo plateenclosure. The L-bracket on and tested acoustically.
fits in an opening under the
d. 1 Rubber hole plugMake sure the horn module
horn assembly. The module
e. 4 Metal coasters will sit on top of the enclo-is playing first. Once the
logo badge and rubber
(to protect wood and tilesure by itself, although itplug hole are installed, it
floors from the spike feet)should always be steadied
is extremely difficult to
4. Carefully unpack the low-until fully mounted. remove them.
frequency enclosure and9. Line up the two mounting
place it upright. It would beholes on the lower lip of the
helpful to position it near itsfront of the horn with those
final position in the roomin the enclosure. Partially
since it is much easier toinstall one long bolt and
move without the additionalthen the other one. It may
weight of the horn module.be necessary to lift the horn
slightly so that the bolts
install smoothly. Do not
force or cross-thread them.
6 |