19L-M100, CL19M10
19L-M100S, 20ML10
Sub-Brightness Adjustment3.58MHz Trap Adjustment
1. Receive a good local channel.1. Receive a good local channel.
2. Make sure the customer brightness control is set to2. Enter the service mode and select the service
center position.adjustment "S16".
3. Enter the service mode and select the service3. This is a two position adjustment, "00" is ON, "01" is
adjustment "S04".OFF.
4. Adjust "S04" data value to obtain normal brightness4. Adjust data value to "00" for normal viewing.
level.
Sharpness, Audio Balance, Energy Save
Vertical-Size AdjustmentOffset, DDE Offset, OSD Setup, Tuner
1. Receive a good local channel.Setup and Option Adjustments
2. Enter the service mode and select the service1. Receive a good local channel.
adjustment "S09".2. Enter the service mode and select the service
3. While observing the top and bottom of the screen,
adjustments "S05" for sharpness, "S17" for balance,
adjust "S09" data value to proper vertical size."S20" for energy save offset, "S21" for DDE offset,
"S22" for OSD setup, "S23" for tuner and "OP" for
Vertical Phase Adjustmentoption.
E Sharpness Adjustment
1. Enter the service mode and select the service
adjustment "S06".3. Adjust data value to "24" (center of data range) for
sharpness adjustment.
2. Adjust data value to "00" ~ "03".
Note:This must be set "00" ~ "03" when changed dataE Audio Balance Adjustment
retrace line will appear.4. Adjust data value to "20" (center of data range) for
audio balance adjustment.
Horizontal Position AdjustmentE Energy Save Offset Adjustment
5. Adjust data value to "23".
1. Have unit receive a good local channel.E DDE Offset Adjustment
2. Enter the service mode and select the service6. Adjust data value to "03".
adjustment "S07".E OSD Setup Adjustment
3. Adjust "S07" data value so that picture is centered.7. Adjust data value to "00".
E Tuner Setup Adjustment
Caption Position Adjustment (Horizontal)8. Adjust data value to "00".
E Option Adjustment
1. Receive a good local channel.9. Adjust data value to "02".
2. Enter the service mode and select the service
adjustment "S18".
3. A black text box appears on the screen. (see Figure
B. below)
4. Adjust "S18" data value so that text box is positioned
in the center of the screen.
Figure B.
11 |
ACEC
SHARP
