21KF-80C
ELECTRICAL SPECIFICATIONS
?Power Input .................... 220V-240 Volts AC 50Hz?Sound Carrier Trap
B/G ................................................ 33.4MHz
?Power ConsumptionD/K ................................................ 32.4MHz
Normal Operation (Method IEC60107) ........ 49W
Stand-by Operation .................................. 3W?Adjacent Sound Carrier Trap
B/G ................................................ 40.4MHz
?Audio Power Output Rating .............. 4W x 2 (MPO)D/K ................................................ 40.4MHz
?Speaker ............................ 16& 4W, 12 x 5 cm, 2pcs?Adjacent Picture Carrier Trap
B/G ............................................... 31.9MHz
?Convergence ................... Self Converging SystemD/K ............................................... 30.9MHz
?Focus ............................... Bi-Potential Electrostatic?Aerial Input Impedance
VHF/UHF .................... 75 ohm Unbalanced
?Sweep Deflection ..................................... Magnetic
?Tuning Ranges ......... 48.25MHz thru 855.25 MHz
?Picture Intermediate FrequencyVHF ......................... CH02-CH12, R01-R12
B/G ................................................. 38.9MHz S1-S41 (HYPERBAND)
D/K ................................................. 38.9MHzUHF ....................................... CH21 - CH69
?White Level
Set the brightness control, with no signal connected, so that the CRT cathode current is 600?A. The maximum
correction applied to each cathode current to achieve a screen temperature of 7250 degrees K-11 MPCD
should not exceed 15% of its original value.
X=0.304 ? 0.015 Y=0.306 ? 0.015
Specifications are subject to change without prior notice.
WARNING
The chassis in this receiver is partially hot. Use an isolation transformer between the line cord plug and
power receptacle, when servicing this chassis.
To prevent electric shock, do not remove cover. No user-serviceable parts inside. Refer servicing to
qualified service personnel.
3 |
ACEC
SHARP
