SAFETY INSTRUCTIONS
3. MufflerControl, maintenance and service of
the machine�s safety equipment
The muffler is designed to
give the lowest possible
IMPORTANT INFORMATION
noise level and to direct the
engineOs exhaust fumes away
YAll service and repairs to the machine require
from the user. A muffler
special training.
fitted with a catalytic
converter is also designed toYThis applies especially to the machine�s safety
reduce harmful exhaustequipment. If the machine does not meet any of
emissions.he controls listed below you should contact
your service workshop.
It is extremely important
YThe purchase of one of our products
that the instructions for
guarantees that professional repair and
checking, maintaining and
servicing will be carried out on it. If the point of
servicing the muffler are
purchase is not one of our servicing dealers,
followed (see the section
please ask for details of the closest service
OControl, maintenance andworkshop.
service of the machineOs
safety equipment�).
WARNING!
WARNING!
Never use a machine with defective safety
Mufflers fitted with catalytic converters
!equipment. The safety equipment should
!become extremely hot during use and
be maintained as described in this
after stopping. This also applies at idling
section. If your machine does not meet
speeds. Contact can result in burns to
any of these controls you should contact
the skin. Be observant to the risk of fire!
your service workshop.
WARNING!
WARNING!
Bear in mind that exhaust fumes:
!Always stop the engine before doing any
Y contain carbon monoxide, which can
!work on the cutting attachment. This will
cause carbon monoxide poisoning.
continue to move even after the throttle
Therefore never start or run the machine
has been released. Ensure that the
indoors.
cutting attachment has stopped
Y are hot and can contain sparks that can
completely and remove the cable from the
cause fires. Never start the machine
spark plug before you start to work on it.
indoors or close to inflammable material.
4. Transport guard
The transport guard (A) is
intended to protect against
any part of the body coming
into contact with the cutting
edges (B).B
The transport guard must
A
always be fitted over the
cutting attachment when
the machine is transported
or stored.
English � 5 |