Before using the washing machine
1.Remove the packaging and 4.Water inlet? The appliance must be
check? Connect the water supply inlet connected to the mains
? After unpacking, make sure hose in accordance with the exclusively by means of a socket
that the washing machine is regulations of your local water with an earth connection in
undamaged. If in doubt, do company (see ?Installation/accordance with established
not use the washing machine. Connect the water inlet regulations. The washing
Contact After-Sales Service or hose?).machine must be earthed by
your local retailer.law. The manufacturer declines
? Check that the accessories and ? Water inlet: Cold water onlyall responsibility for injury to
supplied parts are all present.persons or pets, or damage to
? Keep the packaging materials ? Tap:3/4 threaded property caused by non-
(plastic bags, polystyrene hose compliance with the above-
parts, etc.) out of the reach of connectionmentioned regulations.
children; they can constitute a ? Do not use extension leads or
? Water
possible source of danger.multi sockets.
pressure100-1000 kPa
? Before any maintenance on
2.Remove the transit bolts(flow
the washing machine
? The washing machine is fitted pressure):(1-10 bar).
disconnect it from the mains
with a transport bolts to avoid supply.
5.Drain hose
any possible damage to the
? Access to the mains plug or to
?
interior during transport. Connect the drain hose to the disconnection from mains
Before using the washing siphon or hook it over the edge
supply via a double-pole switch
machine, the transport bolts of a sink by means of the ?U? must be ensured at all times
bend (see ?Installation/
must be removed (see
following the installation.
?Installation/Remove the Connect the water drain ? Do not operate the washing
hose?).
transit bolts?).
machine if it has been
? If the washing machine is
3.Install the washing connected to a built-in damaged during transport.
Inform the After-Sales Service.
machinepumping out system, ensure
? Mains cable replacement is
? Remove the protective foil that the latter is equipped with
only to be carried out by After-
from the control panel.a vent to avoid simultaneous
Sales Service.
? Move the appliance without loading and draining of water
? The washing machine must
lifting it by the worktop.(siphoning effect).
only be used in the household
? Install the appliance on a solid
6.Electrical connectionsfor the prescribed uses.
and level floor surface,
? Electrical connections must be
preferably in a corner of the Minimum housing
carried out by a qualified
room.dimensions:
technician in compliance with
? Make sure that all feet are Width:600 mm
the manufacturer's
resting correctly on the floor
instructions and local safety Height:825 mm
and that the washing machine
regulations.
is perfectly level and stable Depth:600 mm
? Data concerning voltage,
(use a spirit level - see
consumption and fuses are
Installation/Adjusting the
located on the inside of the
Feet).
appliance door.
23 |
ACEC
BAUKNECHT
