Worktop for built-under 1. Pull out the mains plug.4. Refit the fixing screws and
models2. Remove the worktop fixing tighten them.
The appliance must only be screws on the rear of the 5. Connect the appliance to the
installed beneath a continuous appliance.electricity.
worktop.3. Slide the worktop fully
The appliance may only be
built under using the backwards, lift it up and
remove it.
intermediate cover panel of the Install the base set following
UBS base set. This can be the relevant instructions.
obtained from specialist dealers
or After Sales Service.
Connect the water inlet If the hose is too short, replace If the flexible hose is too short,
it with a suitable length of replace it with a 3 m Water Stop
hose
pressure resistant hose (1000 hose (available from After-Sales
For models with straight kPa min, EN 50084 approved Service or from your dealer). This
hose:type).replacement is only to carried
1. Insert the mesh filter Check the inlet hose regularly out by a trained electrician.
(already premounted on the for brittleness and cracks and The appliance must not be
replace if necessary.connected to the mixing tap of an
hose end or included in the un-pressurized water heater.
accessories) into the The washing machine can be Depending on the design, the
threaded tap coupling.connected without a non-
return valve.inlet hose and the plastic
2. Carefully screw the water inlet enclosure at the tap connection
hose connection onto the tap For models with Water contain electrical components.
by hand.Stop hose:Do not cut the hose and do
3. Make sure there are no kinks 1. Screw the threaded not immerse the plastic
in the outlet hose.connection with the mesh enclosure in water .
filter onto the tap.Isolate the appliance from the
4. Turn the tap on fully and mains immediately if the hose is
check that the joints at the 2. Turn the tap on fully and
washing machine and the tap check that the tap joint is damaged.
are watertight.watertight.
Connect the water drain Depending on the
hosemodel, the drain hose
1. Connect the drain hose to Small hand basins are not can be:
the siphon or hook it over suitable.A. installed in the upper part of
the edge of a sink by means To make an extension, use a the washing machine. In this
of the ?U? bend supplied.hose of the same type. Secure case the hose can be undone
2. Make sure there are no kinks the connections with clips.from both fastenings.
in the drain hose.Max. Overall drain hose length: B. Installed in the lower part of
3. Secure the hose so that it 2.50 m
the washing machine.
cannot fall down while the Maximum drain height: 1.25 mImportant:
appliance is running.
In this case never undo the
hose from the right-hand
fastening, otherwise the
appliance could overflow
when operating.
26 |
ACEC
BAUKNECHT
