CARE AND CLEANING
ALWAYS SWITCH OFF THE ELECTRICITYCLEANING THE VITREOUS ENAMEL
SUPPLY AND ALLOW THE COOKER TO COOL
BEFORE CLEANINGUse a clean damp cloth or scourer made for non-
stick saucepans with 'Jif' or 'Flash' cream cleaner.
CLEANING MATERIALS
AFTER CLEANING
Before using any cleaning materials on your cooker,
To maintain the appearance of the hotplates
check that they are suitable and that their use is
recommended by the manufacturer.occasionally apply a little salt free vegetable oil or
commercial restorative agent e.g. '4 Hob' or use a
Cleaners that contain bleach should NOT be used as'Minky' Hotplate Cleaning Cloth.
they may dull the surface finishes. Harsh abrasives
should also be avoided.To apply vegetable oil, first heat the hotplate on a
medium setting for 30 seconds then turn OFF. Pour
a very small amount of oil onto kitchen paper, apply
CLEANING THE SEALED HOTPLATES
the paper to the hotplate and wipe off any excess oil.
AND HOTPLATE TRIMS Heat the hotplate on a medium setting for 1 minute.
In order to maintain the appearance of your cooker'sTo apply restorative agent, apply a thin coating of
sealed hotplates and trims you are advised to use
'4 Hob' or use a Minky cloth following the
the recommended cleaning agents daily. If you domanufacturers instructions.
not allow spillages to burn on they will be much
easier to clean off.CLEANING THE OUTSIDE OF THE
COOKER
THINGS TO NOTE
DO NOT use abrasive cleaning materials, or
The red spot in the centre of the hotplates may bescourers on the outside of the cooker as some of the
removed with some abrasive cleaning agents. This isfinishes are painted and damage may occur.
not a fault and does not effect the performance of theRegularly wipe over the control panel, splashback,
hotplate.oven doors and cooker sides using a soft cloth and
liquid detergent.
FOR NORMAL SOILAGE
Wipe over the hotplates and trims using a clean
damp cloth then switch to a low or medium setting for
a few minutes to thoroughly dry.
FOR HEAVY SOILAGE
Use a clean damp cloth or scourer with a cream
cleaner e.g. 'Jif' or 'Flash' or a powder cleaner e.g.
'Ajax' on the hotplate and trims. Follow the circular
grooved pattern on the hotplate when cleaning.
Rinse off cleaning agents thoroughly. Dry as for
DO NOT ATTEMPT TO REMOVE ANY OF
normal soilage.THE CONTROL KNOBS FROM THE PANEL
For more stubborn marks warm the hotplate on a lowAS THIS MAY CAUSE DAMAGE AND IS A
setting for 30 seconds. Clean the sealed plate withSAFETY HAZARD
'Ajax' powder cleaner, 'Jif' or Flash cream cleaner or
a Brillo pad. You may have to rub hard for several
minutes.
Rinse off cleaning agents thoroughly with a damp
cloth. Switch to a low or medium setting for a few
minutes until the hotplate is thoroughly dry.
CLEANING THE HOTPLATE TRIMS
The stainless steel trims may become straw coloured
during use. Using a proprietary stainless steel
cleaner , e.g. 'Shiny Sinks' will help maintain a bright
appearance. Alternatively a powder cleaner such as
'Bar Keepers Friend' may be used regularly.
27 |
ACEC
TRICITY BENDIX
