SAFETY INSTRUCTIONS
4 Lubricating cutting equipment
Poor lubrication of cutting equipment may
1 Undo the bar nuts thatcause the chain to snap and lead to serious,
hold the clutch cover andeven fatal injuries.
chain brake, using the
combination spanner.
Then tighten the nuts byProlonged inhalation of exhaust gases from
hand as tight as you can.the engine, chain lubrication oil mist and/or
saw dust can be unhealthy.
2 Raise the tip of the barA Chain oil
and stretch the chain byY Chainsaw chain oil must demonstrate good adhesion to the
tightening the chainchain and also maintain its flow caracteristics regardless of
tensioning screw usingwhether it is warm summer or cold winter weather.
the combination spanner.
Tighten the chain until itY As a chainsaw manufacturer we have developed an optimal
not hang slack on thechain oil which, with its vegetable oil base, is also
underside of the bar.
biodegradable. We recommend the use of our own oil for
both maximum chain life and to minimise environmental
damage.
3 Use the combination
spanner to tighten the barY If our own chain oil is not available, standard chain oil is
nuts while lifting the tip ofrecommended.
the bar at the same time.
Check that you can pullY In areas where oil specifically for lubrication of saw chains is
the chain round freely byunavailable, ordinary EP 90 transmission oil may be used.
hand and that it is not
slack on the bottom of theY Never use waste oil!
bar.This is dangerous for yourself, the saw and the environment.
The position of the chain tensioning screw varies from
model to model. See the� What is what� section to find outB Filling with chain oil
where it is on your saw.Y All our chain saws have an
automatic chain lubrication
system. On some models
the oil flow is also
adjustable.
Y The sizes of the chain oil
tank and fuel tank have
been chosen so that the
saw will run out of fuel
before running out of oil.
This means that you should
never run with a dry chain.
However, this safety feature
requires that you use the
right sort of chain oil (if the
oil is too thin it will run out
before the fuel), and that
you adjust the carburettor
as recommended (a weak
mixture may mean that the
fuel lasts longer than the
oil). You should also use the
recommended cutting
equipment (a bar that is too
long will use more chain oil).
The above conditions also
apply to models with an
adjustable oil pump.
14 � English |