Operation of Remote Control (Continued)
POWERDVD/VCR
TVDVD
VCRDISPLAYINPUTPOWER
TV
POWERDISPLAY
123
REMOTE456
KEYPAD
789
FLASHBACKENTER
0100
PERSONAL PREFERENCE
ABCD
CH
VOLVOL
N+
CH
MENUMUTECHANNEL
UP (8)/
CATVTVDOWN ( 9)
DVDVCR
CATV/DVD-TV/VCR
REWPLAYFF
PAUSESTOPRECCH/SKIP
L HOW TO IDENTIFY A VCRSome brands have more than one remote code
The remote control may already be set tolisted, due to changes in the remote codes
operate your VCR. Try this initial check beffrom earorely to later model years, or due to format
going on to the folloOidentifywing � section.differences (VHS/BETA). In such cases, you
(1) Slide CATV/DVD-TV/VCR switch to VCR.may have to try more than one code to find
(2) Point remote towards VCR and press DVD/the code your VCR accepts.
VCR POWER.
(3) Does the remote turn the VCR ON and OFF?Note:
Y If yes, the remote is ready to operate the Depending on the model, yVCRear produced,
and no further steps are needed.brand, and type of VCR, some models may
Y If no, continue to the Oidentify� section.not be compatible with the remote control.
L To Identify Your VCR � Direct Entry Method.L To Identify Your VCR � Search Method.
Use the following steps and list to quic(1)kly findSlide CATV/DVD-TV/VCR switch on the
the remote control code for your accessorremote to yVCR.
VCR.(2) Press POWER on the VCR to ON.
Y First look up your Os remote control codeVCR(3) Stand at least six feet away from the front of
number before going through the direct codethe VCR.
entry steps control.Point the remote towards the VCR.
Y If this procedure does not identify yHold doourwn DISPLAY and CH UP (8) at the
accessory VCR, use the Search method ofsame time. KEEP HOLDING THE BUTTONS
identification (described in the next section).DOWN.
(4) Watch the Channel Number indicator on the
(1) Slide CATV/DVD-TV/VCR switch to VCR.VCR, Channel numbers will scan up when the
(2) Press and hold doDISPLAwn Y and CHVCR has been identified.
DOWN (9) on your remote control.Release DISPLAY and CH UP (8) as soon
Then release both buttons.as the channel numbers start to scan up.
(3) Within ten seconds after releasing DISPLAYThe VCROs remote control code number has
and CH DOWN (9) , enter your Os twVCRo-been identified, and the remote is ready to
digit remote control code number using theoperate the VCR.
REMOTE KEYPAD (refer to list).
Y The remote control is now ready to send
commands to your VCR.
28
25-34 26SL72/29SL82[E].p6.5e284/25/01, 12:06 PM |
ACEC
SHARP
