29UF200
63
DATA
INITIAL
SERVICE MODE 2
CUT OFF
G-DRIVE B-DRIVE
FORWARD: CH DOWN KEY REVERSE: CH UP KEYDATA0 ~ 127
LENGTH
DOWN4 KEY 5 KEY 6 KEY F/B KEY 0 KEY
Press service/language for 2 sec., it will enter into service mode 2.Press service/language for 2 sec. again, it will jump back to service mode 1.3 sec. TIME OUT
" _ / _ _ "
UP3-2
50Hz ADJ. MODESUB 1 ADJ. MODEBKGD MODE1 KEY 2 KEY 3 KEY 7 KEY 8 KEY
CUT OFF
Press the MENU button again at the remote controller, it will jump back to Service Mode 1.LATERAL MODE
(R, G, B-CUT OFF)
CUT OFF / BKGD MODE
CUT OFF MODE60Hz ADJ. MODESERVICE MODE OPTION3 sec. TIME OUTKEY
SERVICE MODE 1R-CUT OFF G-CUT OFF B-CUT OFF G-DRIVE B-DRIVE
63
INITIAL DATA
CUT OFF
R-CUT OFF G-CUT OFF B-CUT OFF
DATA
LENGTH63 ~ 255
SERVICE MODERASTER MODESUB 2 ADJ. MODEPress the MENU button at the remote controller, it will enter into Service Mode Option.
(1) In the Service Mode, Key is used to select the mode in the following order.
C bus control and in the
2
C bus control include preset-only items
2
3-1
2C bus control).
ADJUSTMENT PRECAUTIONS
When the JA373 and JA374 are short-circuited, enter into the service mode. (Adjustment through the I(Use JWS Key to set as well).Press the CH DOWN / UP key on the remote controller to get ready to select the mode one by one.Press the CH DOWN / UP key on the remote controller to select the modes reversibly one by one.Using the VOLUME UP/ DOWN key on the remote controller, the data can be modi- fied.When the short circuit between the JA373 and JA374 is cut off, it will be released from the service mode.Short JA373 & JA374 and turn on the main power switch. Initial values are automatically preset, only when a new EEPROM is used (Judge with the first 4 bytes).The initial data are preset as listed in page.Make sure the data need modify or not (Initial data).
12345123make sure to short JA373 & JA374 to switch to the service mode position first and then turn on the main power switch. (See 2-1 above).Precaution: If havenOt done this initiation, it may possibly generate excessive Beam current.
This modelOs setting are adjusted in two different ways: through the Iconventional analog manner. The adjustments via the Iand variable data.1. Setting the service mode by the microprocessor.2.Factory Presetting.Note:Once the chassis has been assembly together and ready to be POWER ON for the FIRST TIME,
3 |
ACEC
SHARP
