MAINTENANCE
Bevel gearWeekly maintenance
1230,6 - 0,7 mm4
The bevel gear is Ţlled with the right quantity of grease at the
factory. However, before using the machine you should check
that the bevel gear is Ţlled three-quarters full with grease. Use
HUSQVARNA special grease.567
1 Check the starter and starter cord.
The grease in the bevel gear does not normally need to be 2 Check that the vibration damping elements are not
changed except if repairs are carried out.damaged.
3 Clean the outside of the spark plug. Remove it and check
Maintenance schedulethe electrode gap. Adjust the gap to 0,6-0,7 mm or replace
the spark plug. Check that the spark plug is Ţtted with a
Below you will Ţnd some general maintenance instructions. If suppressor.
you need further information please contact your service
workshop.4 Clean the cooling Ţns on the �ywheel.
5 Clean the carburettor compartment.
Daily maintenance
6 Clean the cooling Ţns on the cylinder and check that the
1234air intake near the starter is not blocked.
7 Check that the bevel gear is Ţlled three-quarters full with
lubricant. Fill if necessary using special grease.
56789
Monthly maintenance
10111213
OILOIL
1 Check the engine oil level and top up if necessary.
2 Clean the outside of the machine.
3 Check that the components of the throttle control work
safely. (Throttle lock and throttle control.)
4 Check that the stop switch works correctly.
5 Check that the handle and handlebar are undamaged and
secured correctly.1 Clean the fuel tank.
6 Check that the cutting attachment does not rotate at idle.2 Clean the outside of the carburettor and the space around
it.
7 Clean the air Ţlter. Replace if necessary.
3 Check the fuel Ţlter and the fuel hose. Replace if
8 Check that the guard is undamaged and not cracked. necessary.
Replace the guard if it has been exposed to impact or is
cracked.4 Check all cables and connections.
5 Replace the spark plug. Check that the spark plug is Ţtted
9 Check that the trimmer head is undamaged and not
cracked. Replace the trimmer head if necessary.with a suppressor.
6 Check and clean the spark arrestor mesh on the muf�er.
10 Check that the locking nut is tight.
7 Change the engine oil.
11 Check that nuts and screws are tight.
12 Check that the screws that hold the bevel gear are tight.
13 Check that there are no fuel leaks from the engine, tank or
fuel lines.
English � 19 |