ITEMADJUSTMENT PROCEDURE
HORIZONTAL POSITION1. Call up the adjustment mode display, then select the item HPOS or VPOS.
(HPOS)2. Press the TV/VIDEO button on Remote until the
VERTICAL POSITIONwhite cross-bar or black cross-bar pattern appears
(VPOS)on the screen.
3. Adjust the HORIZONTAL and VERTICAL position
alternately by pressing the VOLUME s or t button
for proper picture position.
4. Check the picture with off-air signal.
HEIGHT1. Call up the adjustment mode display, then select the item HIT.
(HIT)2. Press the VOLUME s or t button to get the picture so the top of raster begins
to lack.
3. Press the VOLUME s button to advance the data by 9 steps.GENERAL ADJUSTMENTS
Note : Check the vertical picture position is correct.
WHITE BALANCE1. Adjust the CONTRAST control to the center, and BRIGHTNESS control to the
(RCUT)maximum.
(GCUT)2. Call up the adjustment mode display, and press the TV/VIDEO button on
(BCUT)Remote until the white and black pattern appears on the screen.
(GDRV)3. Adjust the following item with the CHANNEL s/t and VOLUME s/t buttons.
(BDRV)
RCUT Data : 40H GDRV Data : 40H
GCUT Data : 40H BDRV Data : 40H
BCUT Data : 40H
4. Press the TV/VIDEO button on TV to display a single horizontal line on the
screen.
5. Turn the SCREEN control (FBT) fully counterclockwise and gradually rotate
SPECIFIC INFORMATIONSclockwise until the first horizontal line appears slightly on the screen.
6. Press the TV/VIDEO button to display the normal picture.
7. Adjust the remaining two O?CUT� items (CHANNEL s/t ? TV/VIDEO ?
VOLUME s/t in order) to obtain the slightly lighted horizontal line in the same
levels of three (red, green, blue) colors. The line should be white if the adjust-
ments are proper.
Bright area
Adjust "GDRV" or "BDRV" to be white.
Dark area
Fine adjust "RCUT", "GCUT" or "BCUT" to be black.
PIP SUB-BRIGHTNESS
(PBOF)
PIP WHITE BALANCEAdjust to match the PIP screen to the brightness, white balance and tint of the
(PGOF, PROF)main picture.
PIP SUB-TINT
(PHUE)
� 11 � |
ACEC
TOSHIBA
