MAINTENANCE
Starter deviceTensioning the recoil spring
WARNING!Y Lift the starter cord up in the
notch on the starter pulley
and turn the starter pulley 2
turns clockwise.
Y When the recoil spring is assembled in the starter
housing, it is in tensioned position and can when
NOTE! Check that the
treated carelessly, pop out and cause injuries.starter pulley can be turned
Y Always be careful, when changing the recoil spring orat least half a turn, when the
the starter cord. Always wear safety goggles for eye
protection.starter cord is entirely pulled
out.
Changing a broken or worn
starter cord
Changing the broken recoil spring
Y Loosen the screws, that
hold the starter device
against the crankcase and
remove the starter device.Y Lift the starter pulley (see
"Changing a broken or worn
starter cord").
Y Dissasemble the recoil
spring by tapping the pully
(with its inside facing down)
lightly against a working
bench or similar. If the
Y Pull out the cord approx. 30spring pops out when
cm and lift it up into theassembling, it should be
notch in the pulley. Zero-setmounted again, out and in
the recoil spring by lettingtowards the centre.
the pulley rotate slowly
backwards. Undo the screwY Lubricate the recoil spring
in the centre of the pulleywith thin oil. Assemble the
and remove the pulley.starter pulley, and tension
the recoil spring.
Y Insert and fasten a new
starter cord in the pulley.Starter device assembly
Wind approx. 3 turns of the
starter cord on to the pulley.Y Assemble the starter
Assemble the starter pulley
device, by pulling the starter
against the recoil spring, socord out first, then place the
the end of the springstarter against the
engages to the pulley. Fit
the screw in the centre ofcrankcase. Then slowly
release the starter cord so
the pulley. Carry the starterthat the pulley engages with
cord through the hole in thethe pawls.
starter housing and the
starter handle. Make a knot
Y Assemble and tighten the
on the starter cord.screws, which hold the
starter.
30 � English |
ACEC
HUSQVARNA
