GENERAL SAFETY PRECAUTIONS
Lubricating cutting equipmentChecking chain lubrication
Y Check the chain lubrication each time you refuel. See
instructions under the heading Lubricating the bar tip WARNING! Poor lubrication of cutting
sprocket. equipment may cause the chain to snap,
!
which could lead to serious, even fatal Aim the tip of the bar at a light coloured surface about 20
injuries.cm (8 inches) away. After 1 minute running at 3/4 throttle
you should see a distinct line of oil on the light surface.
Chain oil
Chain oil must demonstrate good adhesion to the chain and
also maintain its �ow characteristics regardless of whether it
is warm summer or cold winter weather.
As a chain saw manufacturer we have developed an optimal
chain oil which, with its vegetable oil base, is also
biodegradable. We recommend the use of our own oil for both
maximum chain life and to minimise environmental damage.
If our own chain oil is not available, standard chain oil is
recommended.
Never use waste oil! Using waste oil can be dangerous to
you and damage the machine and environment.If the chain lubrication is not working:
Y Check that the oil channel in the bar is not obstructed.
Clean if necessary.
IMPORTANT! When using vegetable based saw chain oil,
dismantle and clean the groove in the bar and saw chain
before long-term storage. Otherwise there is a risk of the
saw chain oil oxidizing, which will result in the saw chain
becoming stiff and the bar tip sprocket jamming.
Filling with chain oil
Y All our chain saws have an automatic chain lubrication Y Check that the groove in the edge of the bar is clean.
system. On some models the oil �ow is also adjustable.Clean if necessary.
Y The saw chain oil tank and the fuel tank are designed so
that the fuel runs out before the saw chain oil. Y Check that the bar tip sprocket turns freely and that the
However, this safety feature requires that you use the right lubricating hole in the tip sprocket is not blocked. Clean
sort of chain oil (if the oil is too thin it will run out before the and lubricate if necessary.
fuel), and that you adjust the carburetor as recommended
(a lean mixture may mean that the fuel lasts longer than
the oil) and that you also use the recommended cutting
equipment (a bar that is too long will use more chain oil).
If the chain lubrication system is still not working after carrying
out the above checks and associated measures you should
contact your service agent.
14 � English |
ACEC
HUSQVARNA
