General Information
This ice maker has a sliding panel to cover the ice
thickness control and the cycle switch. To gain
access to the controls remove the screw in the
center and slide panel to the left. (See illustration)
FOR ACCESS TO CONTROLS
REMOVE SCREW & SLIDE
PANEL TO LEFT
SIZING OF ICE CUBES
Your ice maker will produce 32 mm x 32mm(11/~?x11/4?) The ?ON? position of the service switch is for the
cubes or 19 mm x 19 mm (%? x %?) cubelets. Any time a normal ice making cycle. The ?OFF? position stops
change in cube size is desired, the cutting grid can be machine operation. The ?CLEAN? position is used
changed at a modest cost. See your Whirlpool dealer whenever solutions are circulated through the water
for more information. system for cleaning. At this position only the water
pump will operate.
Your ice maker has been preset to produce ice approx-
imately 13 mm (l/z?) thick. The thickness can be in- IMPORTANT: In switch position ?ON?, the cutter grid
creased or decreased by resetting the thickness control, remains energized and placement of metal objects
Figure 1, however best performance will be obtained at on grid wires can cause the grid fuse to open or can
the 13 mm (l/2?) thickness. cause damage to grid wires. To completely deacti-
vate all electrical circuits, the power supply must be
disconnected.
FILTERING & TREATING WATER
In some areas it may be beneficial to filter or treat the
water being supplied to the ice machine to reduce
water system maintenance (see Cleaning & Sanitizing
the Ice Making System) and to produce the best type
of ice.
For information on filtering and treating the water see
your WHIRLPOOL commercial ice maker dealer.
OILING
All components of the ice maker are lubricated at the
factory and should not require any additional oiling
FIGURE 1 -SERVICE SWITCH for the normal life of the machine.
7 |
ACEC
WHIRLPOOL
