Preparing the Telephone for Use
1.2 Handset
Note: Put the base station/charging unit into operation first
before the handset so that the batteries of the handset can be
charged immediately and the handset of the alphaTel 4000 DE is
able to locate "its" base immediately.
The handset of the alphaTel 4000 DL must be registered on the
base station of the alphaTel 4000 DE (or another DECT unit). See
section "Registering/De-registering a Handset."
Installing the batteries
The handset is powered by two chargeable batteries.
1. Hold handset with keys pointing down.
2. Open battery compartment, and insert included batteries. Make
sure poles are correct.
3. To close, slide the cover onto the battery compartment until it
closes tight
Charging the batteries
The included batteries are not charged.
To charge, place the handset on the base station/into the charging
unit.
You will hear a signal tone and see the charging LED of the base
station go on to confirm that the batteries are being charged.
At certain times, the LED goes off briefly. During this time, the
charging status is being checked.
The batteries are fully charged when the LED begins to flash (main-
tenance charge).
Note: Before using the telephone for the first time, charge the
batteries thoroughly. This takes approx. 6 to 7 hours.
New batteries usually achieve their full capacity after several
charge/discharge cycles.
The symbol in the upper right corner of the display indicates the
charging status of the batteries (corresponds to the number of
segments addressed). In addition, appears when the
batteries are empty.
6
*Print Job: , 11.07.01, 19:00 |
ACEC
LOEWE
