5.4. Sequence of Adjustment7. Adjustment of White Balance
(1) DDC data of Analog-RGB7-1. Required Equipment
1) Init the data1) Remote controller for adjustment
2) Color Analyzer (CA-100 or same product)
3) Auto W/B adjustment instrument(only for auto adjustment)
4) AV Pattern Generator
7-2. Connecting diagram of equipment for
measuring (For Auto Adjustment)
COLOR
ANALYZER
216 Level (85 IRE)
TYPE ; CA-100
2) Load the EDID data.(Open File)
[Analog(RGB) : H2_VGA_XGA_RGB(2B52).ANA]
- for VGA,XGACVBS
[Digital(HDMI) : H2_VGA_HDMI(CB50).DVI] - for VGAsignal
input
[Digital(HDMI) : H2_XGA_HDMI(0F0F).DVI] - for XGA
M STG -5200
3) Set the S/W as below.
M SPG -925
4) Push the OWrite Data & Verify�button. And confirm OYes�.
5) If the writing is finished, you will see the OOK� message.
RS-232C Serial Com m unication
6. Auto AV(CVBS) Color Balance
(Fig. 8) Connection Diagram of Auto W/B adjustment
6-1. Required
- This AV color balance adjustment should be performed beforWAuto adjustment Map(RS-232C)
white Balance Adjustment
TypeMF-056A/ MF-056B/ MF-056C
6-2. Required Equipment
Baud RateData bitStop bitParity
1) Remote controller for adjustment
11520081NONE
2) AV Pattern Generator
: 802F Pattern Generator, Master(MSPG-925FA), etc
IndexCmd1 Cmd2Data Min ValueMax Value
(Which has PAL Composite Video format output with
standard(1.0 Vpp) Vertical 100% Color Bar Pattern as Fig 7)R Gainja00(00)255(FF)
G Gainjb00(00)255(FF)
6-3. Method of Auto Color Balance
Protocol
1) Input the PAL Composite Video (Fig7. 100% Color BarB Gainjc00(00)255(FF)
Setting
Pattern) into video input.
R Offsetjd00(00)255(FF)
2) Set the PSM to Standard mode in Picture menu.
3) Press INSTAR key on R/C for adjustment.G Offsetje00(00)255(FF)
4) Press the G(Vol. +) key operate to set, then it becomes
B Offsetjf00(00)255(FF)
automatically.
5) Auto-RGB OK means completed adjustment.
7-3. Adjustment of White Balance
OOperate the zero-calibration of the CA-100, then stick
sensor to PDP module surface when you adjust.
OFor manual adjustment, it is also possible by the following
sequence.
1) Select white pattern of heat-run mode by pressing power
on key on remote control for adjustment then operate heat
run more than 15 minutes.
2) As below Fig.9, Supply 216Level (85 IRE) full screen
(Fig. 7) Auto AV(CVBS) Color Balance Test Pattern pattern to Video input.
3) Press the TV/AV KEY on R/C for converting input mode.
4) Set the PSM to Standard mode in Picture menu.
5) Enter the White Balance adjustment mode by pressing the
INSTART key twice(White Balance) on R/C.
6) Stick sensor to center of the screen and select each items
(Red/Green/Blue Gain and offset) using D / E(CH +/-) key
on R/C.
- 12 - |
ACEC
LG-GOLDSTAR
