SETUP
Manual Convergence Adjustment Mode
NOTES: 1. Please turn ON your television for at least 20 minutes before using this feature.
2. Auto Adjustment Mode is recommended. If convergence is still not acceptable, use the Manual Adjustment Mode.
DO NOT press MAGIC FOCUS or use Auto Adjustment Mode after using Manual Adjustment Mode.
Using the Remote Control, select VIDEO-MAGIC FOCUS-MANUAL ADJUSTMENT MODE-START to access convergence crosshatch
pattern. The adjustment point is indicated by the Adjustment Point Cursor.
To Move Adjustment Point
To move the Adjustment Point Cursor, use the CURSOR buttons. The Adjustment Point Cursor must be WHITE.
Another way to move the Adjustment Point Cursor is to press the followiing buttons: [2] up, [4] left, [5] down, [6] right. If you use the
number buttons while the adjustment point is WHITE, it will change to RED.
To Change the Color of Adjustment Point
Press the SELECT button repeatedly (WHITE-RED-BLUE-WHITE...). Green color is fixed and cannot be adjusted.
To Adjust the Convergence
Move the Adjustment Cursor to the point to be adjusted. Use the CURSOR , , , to match the RED and BLUE colors to GREEN
(reference color). Properly aligned, all three colors should appear white.
VideoSetup
AudioMagic Focus
Ch. ManagerMenu Preference
LocksSet The Clock
SetupSet The Channels
MENUCURSORSet The Inputs
MoveSEL SelCURSORSet Event Timer
Set Closed Captions
About Your TV
MoveSEL Return
CURSOR
Adjustment Point
Cursor
Setup
Magic Focus
Aligns the Red, Green, and Blue
colors to correct for Magnetic
Influences.CURSOR
Adjustment Mode
AutoSELECT
Manual
If you want to adjust nowStart
MoveSEL Return
If convergence is acceptable after Manual Convergence adjustment, press EXIT button to access menu mode.
DONE: [1]
EXITCANCEL: [2]
INI. RESET : [3]
BACK: [4]
Press the [1] button on the remote control to SAVE adjusted data and return to main picture.
ON-SCREENDISPLAYPress the [2] button on the remote control to CANCEL adjusted data and return to main picture.
Press the [3] button on the remote control to recall the factory pre-set convergence data.
Press the [4] button on the remote control to return to the manual convergence adjustment mode (crosshatch pattern).
Press the [9] button on the remote control to read the SAVED adjusted data. If there is no saved data, pressing the [9] button will recall
the factory pre-set data.
48 |
ACEC
HITACHI
