Setting the remote control to work accessory devices
Your remote control is set to work your TV and many infrared remote (IR) control VCRs, Cable TV
Converter Boxes, DVD players, Satellite Receivers, etc.
Press the Select button repeatedly to select DVD/R,CBL,VCR or AUX according to the accessory
device you want to operate with this remote control. See Use of the Remote control, p. 3. Press the
POWERbutton.
If the function buttons on the remote control also work the selected accessory device, then the remote is
ready and no further steps are needed.
If the function buttons do not work with the selected accessory device, according to the device(s) you
own, you may make your remote control ready for them by a direct entry code. Proceed as following.
Code setup§Within 60 seconds from the time the blinking
starts, point the remote toward the accessory
&Press the Selectand POWERbuttons at thedevice and press the POWER button. If the
same time, then release.
é NOTE:When inputting the digits as describeddevice does not respond to the POWER
below, you must not allow more than 20command, follow the steps for programming
the remote again using a different setup code
seconds to pass between the input of each digitfor the type and brand of accessory device you
or you will need to return to step 1 and beginwish to operate. Refer again to the code list on
the programming process again.pages 26-27. If no more codes are listed for the
Input the appropriate digit provided below fortype and brand of accessory device, the remote
the type of accessory device you want to
operate:likely will not operate your particular model of
1 DVD/Raccessory device.
2 CBL (HD-STB)Notes:
3 CBL-SAT- Your TV remote is not necessarily capable of being
4 VCRprogrammed to operate all models of the brands of
5 AUX (AMP, CD).
accessory devices listed on pages 26-27.You may
Input the 4-digit code for the type and brand ofwant to try the programming process again.Try using
accessory device.The codes are listed on pagesthe number(s) that are listed for your type and brand
25-26.of device to be sure you did not make a mistake in
The green light behind the POWERbutton willinputting the digits during your first attempt at
blink for 3 seconds to show that a valid codeprogramming.
was input.- If the remote control is in one of the accessory
If a valid code was not entered, the light willmodes (a mode light is flashing) N DVD/R,CBL,SAT,
stay on continuously for 3 seconds. If thatVCR or AUX N and you donOt press any of the
occurs, go back to step 1 and begin theremote buttons for sixty seconds,a Otime-out�occurs,
programming process again.returning the remote to TV mode.
(Now you will try to use the TV remote with
the accessory device. Press the Select button
on the remote to cycle across the accessory
mode dial. Stop pressing the button when the
mode you desire is lighted.The light will stay on
for 2 seconds and then begin blinking.The
blinking means that the remote is in the
accessory mode you have selected.
25 |
ACEC
PHILIPS
