"After presetting the channels, you may skip unnecessary position numbers so that only the channels you
want to watch are selected.
To preset channels (SKIP) and To preset channels (MFT, AFT, ANT ATT)
To skip unnecessary position numberAFT (Automatic Fine Tuning)
The AFT function automatically corrects slight
Select the position number to be skipped with the
fluctuations when receiving signals.1
CH s t buttons or Number buttons.
Select the channel you want to fine-tune with the
1CH s t buttons or Number buttons.
Press the MENU button, then press the < or >
2button to display the SET UP menu.While in the AFT OFF mode, OR� mark appears to
the left of the position number.
Press the (or ) button to select SKIP.
3Press the MENU button, then press the < or >
2button to display the SET UP menu.
Press the < or > button to select ON.
4
Press the (or ) button to select AFT (on 2nd
3page), then press the < or > button to select ON.
Press the EXIT button to erase the menu display,
5then select the position number to be skipped with
the Number buttons. "*" mark appears to the left of
To use the Aerial attenuator
the position number.
The position number will then be skipped when youWhen visual interference occurs, set the Aerial
selectattenuator (ANT ATT) to ON.
channels with the CH st buttons.SPECIFIC INFORMATIONS
Press the MENU button, then press the < or >
To restore a skipped position number
1button to display the SET UP menu.
Select the position number you want to restore
6with the Number buttons.
Press the (or ) to select ANT ATT (on 2nd
2page), then press the < or > button to select ON.
Select OFF in step 4 above.
Note
7
This setting is effective for the program position you are
now watching.
MFT (Manual Fine Tuning)
The adjustments below are not necessary under normal
receiving conditions. However, in areas of inferior
broadcast conditions where adjustment is necessary for
a better picture, perform the MFT.
Select the channel you want to fine-tune with the
1CH s t buttons or Number buttons.
Press the MENU button, then press the < or >
2button to display the SET UP menu.
Press the (or ) button to select MFT (on 2nd
3page).
Press the < or > button until the best possible
4picture and sound are obtained.
Note
When operating the MFT function, the AFT status is
automatically set to OFF.
� 43 � |
ACEC
TOSHIBA
