USING THE REMO TE TO CONTR OL
DVD FUNCTIONS
Operating the precoded function for your DVD player.
This remote is designed to operate different types of DVD players. You must first program the remote to match the remote system of
your DVD player (refer to page 31 for pre-codes).
1. Turn ON your DVD player.
2. Aim the remote control at the front of your DVD player.
3. Press and release the DVD/VCR button to switch to DVD pre-coded mode.
4. Hold down the DVD/VCR button on the remote and enter the two digit preset code that matches your DVD player, as shown on
page 31.
5. Aim the remote at the DVD player and press the POWER button.The remote will turn off your DVD player when the correct two
digit preset code is entered.When this occurs, the remote control is programmed for your DVD player. If the DVD player does not
turn off, try a different two digit preset code.
6. The remote will now control your DVD player.
POW ER
TVCBL/SATDVD/VCR
NO TES:
a
1. If your DVD player cannot be operated after performingSW AP PIP MODE
PIPFREEZE
OLthe above procedures, your DVD playerOs code has not
PIP CH
been precoded into the remote.VIDEOMENU
2. In the unlikely event that your DVD player cannot be
operated after performing the above procedures, please
CONTR
consult your DVD player operating guide.
SELECT
TE3. The remote control will remember the codes you have
programmed until the batteries are removed from the
MUTELAST CH
remote control.After replacing the batteries repeat theEXIT
entire programming procedure as stated above.
REMOc
VOLCH
THEaDVD/VCR Button
This button allows the remote to control your DVD player by
setting it to DVD mode.
123
b
bPRECODED DVD Buttons456
These buttons transmit the chosen precoded DVD codes.
789
cEXCLUSIVE TV ButtonsANT0INFO
These buttons are for operating the TV.
VID1VID2VID3VID4
RECASPECT VIRTUAL HD
VID5
MY DVD PLAYER CODE IS:
NO TE:Refer to instruction manual of the DVD player for operation of the buttons exclusively for the DVD player.
30 |
ACEC
HITACHI
