PROGRAMMING CHANNELS INTO THE TV'S CHANNEL MEMORY
When you press CHANNEL 8 or 9 on the remote control or TV front panel, your TV will stop only on the channels stored in the
TVOs channel memory.
Follow the steps below to program channels into the TVOs channel memory.
Programming channels automatically
Your TV can automatically detect all active channels in yourTo program channels automatically:
area and store them in its memory. After the channels are pro-
grammed automatically, you can manually add or erase indi-1Make sure you have configured the antenna input sources.GENERAL ADJUSTMENTS
vidual channels.
2Press MENU and open the SETUP menu.
Note:
Y If you already programmed channels automatically3Highlight INSTALLATION and press ENTER. (A new set
during the Quick Connect Guide assisted setup, youof INSTALLATION menu icons will appear on-screen, as
can skip to OManually adding and deleting channelsshown in step 4.)
in the channel memory� on the next page.
Y You must configure the antenna input sources before4Open the TERRESTRIAL menu, highlight CHANNEL
programming channels.PROGRAM, and press ENTER.
Y The automatic channel programming process does
NOT erase channels that were previously pro-5Highlight ANT 1 or ANT 2, depending on which antenna
grammed into the TV's memory, but adds newly foundinput you want to program channels for, and then press
channels to the existing set of programmed channels.ENTER to start automatic channel programming.
To remove a channel from the memory, you mustThe TV will automatically cycle through all the channelsSPECIFIC INFORMATIONS
manually delete it.for the antenna input you selected, and store all active
Y To tune the TV to a channel not programmed in thechannels in the channel memory. While the TV is cycling
channel memory, you must use the Channel Numberthrough the channels, the message OScanning channels,
buttons on the remote control.please wait� appears.
Y Programming channels for an antenna inputTo cancel channel programming, highlight ABORT and
configured for CABLE will take substantially longerpress ENTER.
than for an antenna input configured for ANTENNA.
This is normal; however, once channel programming6When channel programming is done, press CHANNEL 8
is completed, you should not have to repeat the pro-or 9 to view the programmed channels.
gramming process again unless your Cable TV serv-
ice lineup changes significantly.
� 21 � |
ACEC
TOSHIBA
