SETUP
Manual Convergence Adjustment Mode
NOTES: 1. Please turn ON your Projection Monitor for at least 20 minutes before using this feature.
2. Auto Adjustment Mode is recommended. If convergence is still not acceptable, use the Manual Adjustment Mode.
3. If Auto Adjust mode is selected or the Magic Focus button is pressed, all manual adjust mode settings will be erased.
Using the Remote Control, select SETUP-MAGIC FOCUS TUNE UP-MANUAL ADJUSTMENT MODE-START to access convergence
crosshatch pattern. The adjustment point is indicated by the Adjustment Point Cursor.
To Move Adjustment Point
To move the adjustment point cursor using the CURSOR buttons, the Adjustment Cursor must be WHITE. Another way to move the
Adjustment Point Cursor is to press the following buttons: [2] up, [4] left, [5] down, [6] right. If you use the number buttons while the
adjustment point is WHITE, it will change to RED.
To Change the Color of Adjustment Point
Press the SELECT button repeatedly (WHITE-RED-BLUE-WHITE...). Green color is fixed and cannot be adjusted.
To Adjust the Convergence
Move the Adjustment Cursor to the point to be adjusted. Use the CURSOR to match the RED and BLUE colors to GREEN (reference
color). Properly aligned, all three colors should appear white.
VideoSetup
AudioMagic Focus Tune Up
AspectMenu Preference
LocksSet The Clock
Set The Inputs
Setup
MENUSet The Color System
MoveSELSelSELECT
Set Virtual HD
Set Black Side Panel
Set Closed Captions
About Your TV
MoveSEL Select
SELECTAdjustment Point
Cursor
Setup
Magic Focus Tune Up
Aligns the Red, Green, and Blue
colors to correct for Magnetic
Influences.
Adjustment Mode
Auto
SELECT
Manual
If you want to adjust nowStart
MoveSEL Return
If convergence is acceptable after Manual Convergence adjustment, press EXIT button to access menu mode.
117 Manual Adjust
Please Enter Number.
ON-SCREENDISPLAY
0.Cancel and go to Normal Mode.
1.Done and go to Normal Mode.
EXIT
2.Back to Adjust Mode
3.Factory Reset and back to
Adjust Mode.
0-3.Select
Press the [0] button on the remote control to CANCEL adjusted data and return to main picture.
Press the [1] button on the remote control to SAVE adjusted data and return to main picture.
Press the [2] button on the remote control to return to the manual convergence adjustment mode (crosshatch pattern).
Press the [3] button on the remote control to recall the factory pre-set convergence data.
47 |
ACEC
OTHERS
