PROGRAMMING CHANNEL MEMORY
Adding channels to the TVs memory
When you press Channel y or z, your TV will stop only on theNote:
channels stored in the TV?s channel memory.To tune the TV to a channel not programmed
in the channel memory, you must use the
Follow the steps below and on the next page to program all active
Channel Number buttons on the remote
channels into the TV?s memory.
control.
Programming channels automatically
Your TV can automatically detect all active channels in your area and
store them in its memory. After the channels are stored automatically,
you can manually add or erase individual channels.
To program channels automatically:
1. Press MENU, and then press x or ? until the SET UP menu
POWER
TV
appears.CABLE/SATLIGHTSLEEP
VCR
2. Press y or z until TV/CABLE is highlighted, and then pressDVD123
AUDIO1
ENTER to display the pull-down menu.AUDIO2
456
MODE
3. Press y or z to highlight either TV or CABLE, depending on
789
PIC SIZE
which you use. If you use an antenna, highlight TV; if you use+10
ACTION100/0ENT
cable channels, highlight CABLE.MENUOFAVOMENU
INFRITETH
EATER
DELUIINGKTLESUBTI
TITLE
PAUD
SETUFAVIO
ENTER
SET UP
LANGUAGETVENTER
CLOCK SETCABLEyzx ?
ANT 1 / 2
TV / CABLEFAV
CH PROGRAM
ADD / ERASECHVOLChannelyz
EXIT
DVD RTNDVD CLEAR
::SELECTENTER SETCH RTNINPUTRECALLMUTE
SLOW/DIRSKIP/SEARCH
4. Press ENTER.
5. Press z to select CH PROGRAM.
SET UP
LANGUAGEENGLISH
CLOCK SET00:00
ANT 1 / 2ANT1
TV / CABLECABLE
CH PROGRAM
ADD / ERASEADD
::MOVEENTERSTART
6. Press ENTER to start channel programming. The TV will
automatically cycle through all the TV or Cable channels
(depending on which you selected), and store all active channels
in the channel memory.
While the TV is cycling through the channels, the message
Programming NowPlease Wait appears.
7. When channel programming is complete, the message
Completed appears.
8. Press Channel y or z to view the programmed channels.
- 10 - |
ACEC
TOSHIBA
