2.13.6 Magic Focus Initialize2.13.1 Digital Convergence Remote Control
Adjustment Preparation
(1) Receive any NTSC signal. (Set is in Normal mode.)
(2) Digital convergence adjustment should have been
completed.
(3) Set is in DCU adjustment mode.
Adjustment ProcedurePOWER
(1) Press PIP MODE and then PIP CH to initialize
Magic Focus. The initialize operation starts and
VCRCBL
several windows appear during this operation. ItTVSTB
takes about 30 seconds or less.SOURCE WIZARD
(2) When green dots appear, initialize operation isCDTAPE
DVDAMPCURSOR UP
finished.
(3) Turn power OFF.
123
CURSOR
RIGHT
456
CURSOR LEFT
789CURSOR
*INITIAL:N*
DOWN
PHASESLEEP0LAST CH
C.C.HELPASPECT
ANTMODERED
(7X5 Adj.)
Initialization OperationBLUE
(13x9 Adj.)
EXIT
REMARKSMENU
REMOVECROSSHATCH/
Another way to start the initialize operation:COLORVIDEO MODE
(1) Press SERVICE ONLY Sw. on CONVER/FOCUS
SELECT
PWB to set DCU adj. mode.VOLCH
(2) Press [PIP MODE] key on R/C. Then ROMADJUSTMENT
WRITE? is displayed for alarm. Next, press [PIP
GREEN
CH] key on R/C to start initialization. When greenSVCSMUTE
STATUS(3X3 Adj.)
SCHD
dots appear, initalization operation is finished.VCR PLUS+
VID 1INFOGUIDE/TVGUIDE/TVGUIDE/TVGUIDE/TVVID 5
RASTER
NOTE: If there is an error message, red dots or an error
VID 2POSITION
VID 4
code, refer to page 57, CONVERGENCEVID 3
ERRORS.PIPPIP CHFREEZECALCULATION
PIP ACCESS
PIP MODESWAPINITIALIZE
*[PIP MODE]* key is same function as current [MOVE]
(Corner
key.ROM WRITE
PROGTV/VCRSLOWAdjustment)
ROM READ
REC
CLU-5713TSI
494949 |
ACEC
HITACHI
