MAINTENANCE
Y Undo the screw in the centre of the pulley and remove the Fitting the starter
pulley. Insert and fasten a new starter cord to the pulley.
Y To Ţt the starter, Ţrst pull out the starter cord and place the
Wind approx. 3 turns of the starter cord onto the pulley. starter in position against the crankcase. Then slowly release
Connect the pulley to the recoil spring so that the end of
the spring engages in the pulley. Fit the screw in the centre the starter cord so that the pulley engages with the pawls.
of the pulley. Insert the starter cord through the hole in the Y Fit and tighten the screws that hold the starter.
starter housing and the starter handle. Make a secure
knot in the end of the starter cord.
Air Ţlter
Tensioning the recoil spring
The air Ţlter must be regularly cleaned to remove dust and dirt
Y Hook the starter cord in the notch in the pulley and turn the in order to avoid:
starter pulley about 2 turns clockwise.
Y Carburettor malfunctions
Note! Check that the pulley can be turned at least a further Y Starting problems
1/2 turn when the starter cord is pulled all the way out.;Y Loss of engine power
Y Unnecessary wear to engine parts.
1
Y Excessive fuel consumption.
2
Changing a broken recoil spring
Y Remove the air Ţlter after taking off the air Ţlter cover. When
reŢtting make sure that the air Ţlter seals tightly against the
Ţlter holder. Clean the Ţlter by brushing or shaking it.
Y Lift off the pulley. See instructions under heading
Changing a broken or worn starter cord.
Y Remove the recoil spring from inside the pulley by tapping
the pulley lightly with its inside face downwards against a
work bench or the like. If the spring pops out during Ţtting,
wind it up again, working from the outside in towards
centre.
Y Lubricate the recoil spring with light oil. Fit the pulley and
tension the recoil spring.The Ţlter can be cleaned more thoroughly by washing it in
water and detergent.
An air Ţlter that has been in use for a long time cannot be
cleaned completely. The Ţlter must therefore be replaced with
a new one at regular intervals. A damaged air Ţlter must
always be replaced.
A HUSQVARNA chain saw can be equipped with different
types of air Ţlter according to working conditions, weather,
season, etc. Contact your dealer for advice.
English � 33 |
ACEC
HUSQVARNA
